Mark Feldstein Dual Recording Picture Frame User Manual

Dual Recording Photo Frame

Your Dual 4” x 6” Recording Picture Frame lets you record
and play back up to 10 seconds of sound to accompany
each of your favorite pictures. Its recorder uses the latest
integrated circuit recording technology, so you can record a
new message as many times as you like without having to
wait for a tape to rewind. You can place the frame
horizontally or vertically.

REMOVING THE BATTERY INSULATION
STRIP

To prevent battery drain during shipping, your recording
picture frame is shipped with an insulation strip that you
must remove before use. To remove the strip, firmly grasp
the slip by its end gently pull it out.

FRAMING A PHOTO

1. Open the picture frame.

2. Place the picture frame vertically on a flat surface then

3. Turn the inner picture frame over and slide down the

4. To frame a 3” x 5” photo, place the photo on the

5. Position the metal plate with its two convex ribs facing up,

press the button on the top of the outer picture frame to
pop out the inner picture frame.

metal plate until its six slots align with the six holding tabs
on the back of the inner frame. Then lift off the metal
plate. Remove the sample picture.

silver-bordered plastic plate (PVC). Then place the
all-clear plastic plate on the top the photo. Slide them

into the picture frame.
To frame a 4” x 6” photo, place the photo on the all-clear
PVC plate, then place the silver-bordered PVC plate on
the top the photo. Slide them into the picture frame.

then align its six slots with the six holding tabs on the

this

OPERATION INSTRUCTION – Please read before using

picture frame and push the plate until it reaches the top

of picture frame.

6. Insert the inner picture frame’s three lockin g tabs into the
matching slots on the lower end of the outer frame, and
then press the top of the inner frame down until it clicks
securely into the outer frame.

7. Repeat Step s 2-6 for the other inner picture frame.

photo frame.

RECORDING A MESSAGE

Follow these steps to record a 10-second mes sage for ea ch
picture frame.

1. Open the picture frame and hold it about 6 inches (15 cm)
away from your mouth or the sound source.

2. Use the tip of a pen (or other pointed object) to hold
down REC. The recording indicator lights and recording
begins.

3. Speak into MIC. After 10 seconds, recording stops
automatically and the recording indicator goes off. To
stop recording sooner, release REC.

Repeat these steps to record a new message. The new
message replaces the old one.

PLAYING THE MESSAGE

Press PLAY to listen to the message.

PLACING THE PICTURE FRAME

You can place the picture frame vertically or horizontally on
a desk, shelf, or table.
To place the picture vertically, open and extend the picture
frame, then place it on a flat surface.

REPLACING BATTERIES

Your recording picture frame comes with two type AG13
alkaline button-cell batteries installed. When the sound
weakens, replace the batteries. The recorder keeps the
message stored even if it loses battery power.

Warnings:


Keep button-cell batteries away from children
a button-cell battery can be fatal.

 Dispose of old batteries promptly and properly. Do not

burn or bury them.

Cautions:
 Use only fresh batteries of the required size

and recommended type.

 Do not mix old and new batteries, different types of

batteries (standard, alkaline, or rechargeable), or
rechargeable batteries of different capacities.

. Swallowing

1.

Use a mini Phillips screwdriver to re move the two
screws on the battery compartment cover on the hinges
back, and then lift off the cover.

2. Remove the old batteries. Place the fresh batteries in
the compartment as indicated by the po la r ity symb o ls, ( +
and -) marked inside.

3. Replace the cover and secure it with the screws.

CARE

Keep the frame dry; if it gets wet, wipe it dry immediately.
Use and store the frame only in normal temperature
environments. Handle the frame carefully; do not drop it.
Keep the frame away from dust and dirt, and wipe it with a
damp cloth occasionally to keep it looking new.
Modifying or tampering with the frame’s internal
can cause a malfunction and migh t invali date i ts warranty. If
your frame is not performing as it should, take it to your
local store for assistance.

Mark Feldstein & Associates, inc.
www.markfeldstein.com

components