Mark Feldstein 8IN User Manual

OPERATIONS MANUAL

8 inch Original Singing Bird Clock

IMPORTANT!

sound is heard for each hour.

SETTING THE TIME:

1) Turn the hand set knob in rear of movement clockwise or counterclockwise to read 10 minutes before 1:00 o’clock.
(12:50)

2) Insert 3 “AA” size batteries (not included) into the battery compartments. Make sure that the
battery polarity (+/-) is as indicated.

3) Turn the handset knob to adjust to desired time.

Note: Each time the set test (red) button is pressed, this resets sounds to the next hour. If pressed, you must follow the
instructions above to reset properly or you will not hear the correct sounds with each hour.

HOURLY SOUNDS

1:00 –American Robin
2:00 –Northern Mockingbird
3:00 –Blue Jay
4:00 –House Wr e n
5:00 –Tufted Titmouse
6:00 –Baltimore Oriole
7:00 –Mourning Dove
8:00 –Black-capped Chickadee
9:00 –Northern Cardinal
10:00 –White-throated Sparrow
11:00 –White-breasted Nuthatch
12:00 –House Finch

LIGHT SENSOR (CDS)

This clock has a silence function controlled by a light sensor positi oned ab o ve the 12 o’clo ck posit ion. The light sensor
automatically turns the sounds off when the room is dark. If the sounds are low, please move to a bri ghter area of the
room.

GENERAL INFORMATION

T o clean the outside surface, use a clean, dry, soft cloth to wipe aw ay fingerprints or dust.
Do not use any solvents or abrasive cleaners or polish.

BATTERY NOTICE

1) Do not mix old and new batteries. Do not mix alkaline, standard (Carbon-Zinc), or rechargeable (Nickel Cadmium)

batteries. To avoid leakage or explosion, do not put batteries in fire.

2) Replace the batteries if the timekeeping becomes erratic or hourly sounds become abnormal, as this may be an

indication that batteries are becoming worn out.

3) Remove the batteries if product is to be left unused for a long time. Clean the battery contacts prior to battery

installation.

Batteries not included
Country of origin: China
Mark Feldstein & Associates, inc.
www.markfeldstein.com

The following instructions must be followed exactly to ensure that the correct

(Remove batteries before beginning)

Test Button