Operating Instructions
1. Use the On - Off switch on bottom of candle
to turn LED to On Flicker position or OFF position. (see A)
2. Switch to “off” when not in use.
3. To replace the included button cell (CR2032) open bottom
battery compartment cover, install one CR2032 battery,
replace battery compartment cover. Make sure polarity (+)
faces out as indicated. (see B).
This device compli es with Part 15 of the FCC Rule s. Operation is subject to the
following two cond itions: (1) This device may no t cause harmful interference, a nd
(2) this device mu st accept any interference rece ived, including interference th at may
cause undesired op eration.
Caution: Changes o r modications not expressly ap proved by the party responsible
for compliance cou ld void the user’s authority to operate the equipment.
NOTE: This equipme nt has been tested and found to comply with the limits for
Class B digital de vices, pursuant to part 15 of t he FCC rules. These limits are
designed to provid e reasonable protection against harmful interference in a resi dential
installation. This equipment generates, uses and can radiate radio frequency ene rgy
and, if not instal led and used in accordance with the instructions, may cause ha rmful
interference to ra dio or television reception, wh ich can be determined by turnin g the
equipment off and on, the user is encouraged to t ry to correct the interference by one
or more of the fol lowing measures:
• Reorient or relo cate the receiving antenna.
• Increase the sep aration between the equipment a nd the receiver.
• Connect the equi pment into an outlet on a circu it different from that to which the
receiver is con nected.
• Consult the deal er or an experienced radio/TV t echnician for help.