Market Forge ST-5G User Manual

GAS COUNTERTOP

G

MODEL

 ST-5G - 5 pan gas countertop convection steamer

DESCRIPTION

A Market Forge Model ST-5G convection steamer with gas steam
generator. The cavity shall be 5 pan capacity. The steamer shall be
constructed from stainless steel type 304 with a cooking chamber
of one-piece all welded type 316 stainless steel with coved corners.
The heavy duty door shall have an inner liner of stainless steel with
a full perimeter gasket seal, an outer liner of one-piece all welded
stainless steel and a positive lock and seal mechanism with spring

release.

The compartment shall be provided with removable stainless steel
pan supports. A stainless steel drip trough shall be integrally con­nected to drain to collect condensate when the door is opened.

The control housing shall be constructed of stainless steel with a
full access removable panel. The compartment shall have controls
which include an illuminated on/off power switch, pilot ready light,
pilot cooking light, ignition light, 60 minute timer, solid state gen­erator controls, and electronic ignition. Steam flow to the cooking
chamber shall be cut off when door is opened and reactivated when
the door is closed.

Standard features include an automatic generator blow-down,
deliming port (located: right side of unit), delime light indicator, and
split water connections.

Gas Countertop Steamer

CONVECTION STEAMER

JOB NAME: ___________________________

ITEM NO.: ____________________________

NO. REQUIRED: _______________________

Shown with Standard 4” Adjustable Counter Feet

FOOD SERVICE EQUIPMENT

TECHNICAL SPECIFICATIONS

 A gas fired stainless steel steam generator operating at 0 PSI

(0kg/cm2) and rated at 42,000 BTU.

 The generator shall be equipped for operation on:

 Natural Gas
 LP Gas

 The controls shall be equipped for operation at 120 VAC, 1pH,

50/60 Hz

CAPACITY:

 (8) 12” x 20” x 1” deep pans
 (5) 12” x 20” x 2-1/2” deep pans
 (3) 12” x 20” x 4” deep pans
 (2) 12” x 20” x 6” deep pans

SHIPPING WEIGHT

 ST-5G - 275 lbs (125)

OPTIONS & ACCESSORIES

(at additional charge)

 Pans & Covers

 12” x 20” pan cover
 12” x 20” x 1” solid pan
 12” x 20” x 1” perforated pan
 12” x 20” x 2-1/2” solid pan
 12” x 20” x 2-1/2” perforated pan
 12” x 20” x 4” solid pan
 12” x 20” x 4” perforated pan

 12” x 20” x 6” solid pan
 220 VAC, 1pH, 50/60 Hz
 28” tall stainless steel stand with shelf
 Prison package, includes lockable stainless steel hinged

control cover, tamper proof screws, (4) 4” adjustable flanged
feet, insulated flue cover

 Filter System
 4” flanged feet
 Quick disconnect water lines ( 2) required

44 Lakeside Avenue, Burlington, VT 05401 USA • Tel: [phone] • Fax: [phone]

www.mfii.com

G

GAS COUNTERTOP

CONVECTION STEAMER

DETAILS & DIMENSIONS

SERVICE CONNECTIONS

G Gas Connection - 3/4” (19mm) NPT supply line required.

GW Generator Water - 3/8” (10mm) O.D. tubing at 25-50 PSI

(1.8-3.5kg/cm2)

E Electrical Connection - Unless otherwise specified, field

wire electrical connection to be 120 Volts, 60 Hz and 1pH
with grounding wire. Furnished with 6’ cord and 3 prong
plug. Maximum Amps 2.0.

CW Condensing Water - 3/8” (10mm) O.D. tubing at 25-50

PSI (1.8-3.5kg/cm2)

D Drain - 1” (25mm) NPT piped to open floor drain. DO

NOT MAKE SOLID CONNECTION TO THE FLOOR.
24” length before open air gap opening. NO BENDS OR
ELBOWS.

DP Delime Port - 3/4” NPT

WATER QUALITY STATEMENT

CAUTION: Before connecting water to this unit, water supply
should be analyzed to make sure hardness is no greater than 2.0
grains and pH level is within the range of 7.0-8.5. Water which
fails to meet these standards should be treated by installing a
filter or conditioner. EQUIPMENT FAILURE CAUSED BY

INADEQUATE WATER QUALITY IS NOT COVERED
UNDER WARRANTY.

GAS REQUIREMENTS

Gas Countertop Steamer

MODEL FUEL BUT/HR. kW/HR.

FOOD SERVICE EQUIPMENT

ST-5G

Natural 42,000 13.2 Min. 4” (120mm)

Propane 42,000 13.2 Min. 11” (279mm)

WATER COLUMN

PRESSURE

DIMENSIONS ARE IN INCHES [MM]

24 [610]

1.12
[29]

32

[813]

16.75
[425]

D

1

[25]

9

[299]

D

GW

E

G

E

5.25 [133]
3 [76]

1.75 [44]

2.38 [60]

CW

12

[305]

DP

20.75
[527]

DP

40.38

[1026]

PRINTED IN U. S. A.
SPEC SHEET: 14-0070 Rev B (3/15)

GW

4 [102] MIN.

The manufacturer reserves the right to modify materials and specifications without notice.

44 Lakeside Avenue, Burlington, VT 05401 USA • Tel: [phone] • Fax: [phone]

G

16 [406]

CW

5 [127]

4 [102]

1.75 [44]

www.mfii.com