Market Forge MT-25EO Installation Manual

MT 25/40 GALLON SERIES

MODULAR BASE ELECTRIC TILTING KETTLES

INSTALLATION - OPERATION - MAINTENANCE

MODELS

 MT-25EO
 MT-40EO

44 Lakeside Avenue, Burlington, Vermont 05401 USA

Telephone: [phone] Fax: [phone]

www.mi.com PN 14-0330 Rev D (4/16)

© 2016 - Market Forge Industries Inc.

Your Service Agency’s Address:

Model

Serial number

Kettle installed by

Installation checked by

IMPORTANT

TABLE OF CONTENTS

WARNING: Improper installa­tion, adjustment, alternation,
service or maintenance can
cause property damage, in­jury or death. Read the instal­lation, operation and mainte­nance instructions thoroughly
before installing or servicing
this equipment.

FOR YOUR SAFETY

Do not store or use gasoline or
other ammable vapors or liq­uids in the vicinity of this or any
other appliance.

The information contained in this
manual is important for the prop­er installation, use, and mainte­nance of this kettle. Adherence
to these procedures and instruc­tions will result in satisfactory
baking results and long, trou­ble free service. Please read
this manual carefully and retain
it for future reference.

INSTALLATION

Introduction .............................................................. 2

Service Connections ..................................................... 3

OPERATION

Operating Instructions .................................................... 4

Cooking ................................................................. 5

Cooking Facts for Steam Jacketed Kettles .................................. 6

Cooking Chart ........................................................... 7

MAINTENANCE

Daily Kettle Cleaning ..................................................... 9

Cleaning the Boiler ...................................................... 10

Application Instructions for Total Concept Descaler ......................... 11

ERRORS: Descriptive, typo­graphic or pictorial errors are
subject to correction. Speci­cations are subject to change
without notice.

Introduction

DESCRIPTION

Market Forge model MT-25EO (25-gallon) and MT-40EO
(40-gallon) are self-contained tilting electric steam jack­eted kettles. Each kettle has a jacket of double-wall con­struction forming a sealed reservoir around the lower two­thirds of the kettle.

The stainless steel kettle is enclosed in a cabinet base
containing a 24 kW electrically powered boiler for kettle
operation.

BASIC FUNCTIONING

The kettle becomes operational when the power switch is
placed in the ON position. At this point, the boiler reservoir

begins to ll with water automatically until the water level

reaches a factory preset, high water level. At the high wa-

ter level, incoming water ow is shut off.

Once the water level is sufciently above the heating el-

ements, the heater rest switch is momentarily placed in
the ON position. The action releases closing contactors
to heating elements.

After steam pressure builds up to proper operating pres­sure, the steam control valve on the cabinet top can then
be manually operated. This open valve allows steam to
ow into the kettle jacket-heating both the kettle and con­tents. As water level drops due to steam conversion, the
automatic water level control system opens and closes
the incoming water valve to maintain constant water level.
If the level control system fails, and automatic low water
cut off switch turns off power to heating elements.

SERVICE

Required service, both repair, replacement, and adjust­ment is explained in Adjustments section of this manual.
Other service help can be found in the Trouble Shooting
and Maintenance sections of this manual. Should repairs

be required, a network of Authorized Service Agents is

available to assist with prompt service. A current list of Au-

thorized Service Agencies may be obtained by contacting

Market Forge direct of going on our website http://www.

mi.com.

The model and serial number must be referenced when
corresponding with Market Forge. These numbers can
be found on the data plate located on the upright frame
behind the cabinet base door. If you require further as­sistance in obtaining these numbers, please contact us
directly.

INSTALLATION

2