Markant MAX display User Manual

MAX display manual

› MAX display manual

Before using the system carefully read this

manual and store the manual for reference

User manual for MAX sit/stand

desks 65-128 cm

MAX display manual

› MAX display manual

Handset 3

Drive up/down 3

Saving preferred height 4

Moving to a saved preferred position 4

Setting of indicated height 5

Reset procedures 6

Contents

MAX display manual

› MAX display manual

Handset

Drive up/down

This function serves for an easy height adjustment of the desk.

›

Press or .
The keys have to be pressed until the desired height of the desk has been reached. The display always shows
the actual height.
For example:

The desk moves as long as the keys are pressed or until the end position is reached.

Buttons for setting

desired height

Display

Lower

Drive

Higher

Memory button

MAX display manual

› MAX display manual

Saving preferred height

Moving to a saved preferred position

This function is for saving a preferred desk height. 4 preferred heights can be saved.

›

Move to the desired desk height.

›

Press . You will see the following:

›

Press one of the keys:

After having pressed the position key “S” and the number of the position key is displayed.
For example:

At the end of the memory procedure a double ‘Click’ is heard and after 2 seconds the actual height is read again.

For example:

This function allows the desk to move to a saved preferred height.

›

Press and hold one of the keys:

If the memory key is pressed for a second time the actual height is shown on the display and
nothing is saved. If the position key is not pressed again within 5 seconds after having pressed the
memory key the actual height will appear again on the display and nothing is saved.

If any other key is pressed while the desk is moving towards the saved position the desk stops.

The desk moves towards the position as long as the key is pressed. After reaching the saved height or if the
key is not pressed anymore the desk stops.

= Attention

MAX display manual

› MAX display manual

Setting of indicated height

With this function the indicated height can be changed.

›

Press . You will see the following:

›

Press and hold for about 5 seconds until the display starts ashing.

For example:

›

Now you can set the height with or with .
During this procedure the desk does not move.

›

If the position is correctly set the new height can be saved by pressing .

The position is saved and the display stops ashing.
The new height is also saved if no key is pressed within 5 seconds and the display stops ashing.

If the next key is not pressed within 5 seconds the control returns to standard mode again.

If the sequences described below are not observed the control returns to standard mode again
and can be normally operated.

= Attention

MAX display manual

› MAX display manual

›

Press and hold to go to the preferred height.

›

Amending the height in the display by using or .

Press for higher.
Press for lower.

›

Conrm with .

After conrmation the actual height can be read o of the display (display does not ash anymore) and

the system is ready for further programming.

Reset procedures

If the desk is not aligned in a proper way or an other motor is connected to the programmed system the

software has to be reset.

›

Press and all at the same time and keep the keys pressed until the display shows “S7”.

If “S7” is not displayed press until “S7” is displayed.

›

Press to conrm.

Display ashes ”088”.

›

Press until the highest position is reached. Motor stops automatically.

Motor works with half speed; going down is not possible.

›

Measure the actual height from top to oor.

›

Put this height in the display using keys or .

Press for higher.
Press for lower.

›

Press to conrm.

After conrmation the display ashes “068”.