Mark MULTIPROFILE ZOOM 15-30, MULTIPROFILE ZOOM 25-50 User Manual

MULTIPROFILE ZOOM

15-30 25-50

User Manual/Manual de Uso

Rev. 13.09.01

I. General Introduction

This multiprofile spot, adapts the advanced design of cold light sources and the reflector bowl
specially designed.
It disposes of dual convexes lens and is characterized by high light efficiency, equal light spot
distribution and low light beam temperature. With the help of imaging gobos or iris, it can
get extremely clear project images. In addition, the light body adapts the high-pressed cast
aluminium shell of high quality that has a beautiful and graceful shape and heat dissipation, with
the assistance of the infrared penetrateable reflector bowl, the temperature around the bulb is
reduced, prolonging the life of the bulb. This light can be used as a spotlight, also
can be used for special shaping. With its reliable, endurable design, it is ideal light for modern
stage.
They can be easily regulated to produce lightspots with a lighting angle of 15º-30º or 25º-50º
turning the dial (2).

1. Drawtube

2. Lens adjustment dial

3. Slot for Iris

4. Slot for Gobo Holder

5. Handle

6. Lighting adjustment flake

7. Nut for suspensions Loop

8. Bulb adjustment screw

9. Screw for lamp holder

10. Lamp holder handle

11. Lock

12. Color frame clip

13. Color frame fixer

14. Lamp holder

15. Screw for design adjustment tube

MULTIPROFILE ZOOM 15-30

MULTIPROFILE ZOOM 25-50

MULTIP. ZOOM 15-30, 25-50 User Manual/Manual de uso Page 1

2. Specificactions and Technical Features

Power Supply AC 230 V 50/60 Hz
Power 750 W
Weight Approx. 6 Kg
Lamp Model G 9.5

3. Use and Operation

1. Installing the Bulb
Loosen the screw for the lamp holder (9), turn out the lamp holder, insert the bulb

into the lamp holder, note that the lamp should be aproximately perpendicular to
the lamp holder and the screw down the screw for lamp holder (8).

2. Adjusting

Draw out the handle (5), connect the power supply, the light is
on, adjust the Bulb Adjustment Screw (8) until the lightspot are the brightest, loosen
the Screw for the Front Drawtube (15), adjust the Front Drawtube (1) fore and aft
until the margin of the light spots are the clearest.

3. Gobo Holder

If you want to get the effect of the design, you must firstly make the design gobo
showing inverse images. Placing it in the slot (3) and then move it forward until
the Design Bayonet comes out and then insert thedesign flake. Turn on the
light, adjust the Front Drawtube (1) until getting the clearest design, then
fasten the Front Drawtube.

4. Color Effect
If want a color effect, please clip the color filter with the filter holder , open the

color frame clip (13) and insert it.

5. Cleaning the lens
Note. If the surface of the lens has been damaged obviously, please change the

lens.
Warning. Never use a detergent for glasses or windows, or the rigid cloth to clear
lens, because the detergent for glasses and windows can pollute the surface of
the lens and this type of cloth can damage the surface of the lens. Use a soft cloth
lightly wet with water.

MULTIP. ZOOM 15-30, 25-50 User Manual/Manual de uso Page 2