Marinco - Actuant Electrical 28210 Specifications
Printed copies of this specification are for information purposes only and are uncontrolled. Printed copies are
REFERENCE SPECIFICATIONS after the date of printing. This document was printed on 1 May, 2015.
Page 1 of 4
Height 5.5 inches
14.0 cm
Width 7.8 inches
19.7 cm
Depth 2.4 inches
6.2 cm
SPECIFICATION SHEET Rev. 1.0
PRODUCT NUMBER: 28210 - Marinco On-Board Battery Charger
This 28210 model is a 2 bank, 10 amp, 12/24V DC output charger with wide input voltage range (100-240V AC), is
microprocessor controlled and has a maintenance mode that will keep the charger fully charged. The Marinco
28210 meets the CEC (California Energy Commission), FCC, CE, is RoHS compliant and has UL and CSA listings
(cULus). The 28210 has the same mounting dimensions as the Guest 2611A and 2611A-B and replaces these
models.
1. DESCRIPTION
1.1. Dimensions Reference only
1.2. Mounting Bulkhead mount (vertical at wall)
Hole diameter is .245 inches / .622 cm or clearance for #10 screw
Left to Right Center to Center = 7.00 inches / 17.78 cm
Top to Bottom Center to Center = 4.25 inches / 10.8 cm
1.3. Weight (reference)
Approximately 5.6 lbs. (2.5 kg)
Printed copies of this specification are for information purposes only and are uncontrolled. Printed copies are
REFERENCE SPECIFICATIONS after the date of printing. This document was printed on 1 May, 2015.
Page 2 of 4
Red
Green
Soft start
On
Off
Bulk
On
Off
Absorption
On
On
Float
Off
On
SPECIFICATION SHEET Rev. 1.0
1.4. Connection
1.4.1. AC
6’ (1.8 m) AC Cable with NEMA L5-15P AC Plug. Cable consists of 18/3 SJT cord with one
BLACK (HOT), one WHITE (NEUTRAL) and one GREEN (GROUND)
1.4.2. DC
4’ (1.2 m) DC output cable, 14 gauge wires, SJT with ring terminal connection
2. FEATURES
2.1. Sense-Send™
Technology senses the power needs of each battery and sends correct charge regardless of
Serial or Parallel output connections.
2.2. Waterproof
The Marinco 28106 has an IP68 rating. This rating is described as dust tight and protected
against the effects of immersion in water under pressure for long periods.
2.3. Charge Indicators
Unit has 2 LEDS, one Red and one Green in color. The following table should be used as
indicator of the charger status.
2.4. Protection
Ignition Protection
Over Current
Over charge
Reverse Polarity
Thermal Protection
Short Circuit
2.5. Temperature Characteristics
Ambient Operating Temp Full Power -40 C to 50 C
Storage Range -40 C to 70 C
Loading...