MARIAN ADCON User Manual

ADCON

User’s Guide

The ADCON conforms the following standards:
EN 55022: 1998 + A1: 2000 + A2: 2003; class A
EN 55024: 1998 + A1: 2000 + A2: 2003; class A

In order for an installation of this product maintain compliance with the limits of a class
A device, shielded audio cables must be used, not longer than 50 cm. Attention: This is
a device of the class A and can cause interference to radio or television reception
within the residential area. The user is encouraged to try to correct the interference by
suitable measures.

© April 2007, Marian, v1.07
Hardware Design by Marian
User’s Guide by Wilke Pfannkuch – Hamburg, Germany

This User’s Guide is copyrighted. All rights reserved. No part of this User's Guide may be reproduced
or transmitted in any form or by any means, electronically or mechanically, including photocopy,
translation, recording, or any information storage and retrieval system, without prior and expressive
permission in writing from Marian.
All trademarks are the property of the respective owners.

Marian is not liable for any damage and costs resulting from it, which are caused by improper handling
or installation of the device.

Technical changes are reserved.

Table of Contents

1.

Scope of Supply 2

2.

Ports and Operating Elements 3

2.1.

Front Side 3

2.1.1. Using Microphones for Ports on the Front Side 4

2.2.

Back Side 5

3.

Operation 6

3.1.

Rack Installation 6

3.2.

Power Supply 6

4.

Technical Data 7

5.

Service and Support 7

2

Dear User,

thank you very much for your decision to purchase ADCON as high­quality ADAT converter. We wish you lots of success in working with
our product.

Please consider taking 10 minutes to study this guide. Besides
traditional installation and operation instructions it contains information
about synchronization and operation of ADCON that will make the
handling with the device easier for you.

Your ADCON provides some special characteristics. In the following
you will get a short overview:

- Balanced inputs and outputs

- Individually switchable input level: –10 dBV or +4 dBu

- Additional input jacks of channels 1 and 2 on the front side

For inputs 1 and 2 on the front side:

- Microphone pre-amplifier

- Phantom power supply

- Gain Level control

1. Scope of Supply

First of all, please check, whether you received the following
components undamaged and complete:

- ADCON, ADAT converter

- Power supply with cable

- User's Guide

Please send back the device with possibly existing damage to the
supplier only after notifying the transportation company and the
sender, otherwise you will lose your claim for damages.