Maretron M003017 User Manual

Installation Instructions
10271 1-1/2" FPT Cooling Water Flow Switch
Introduction
The Maretron 10271 is an accessory for the SIM100 Switch Indicator Module. The 10271 has a set of normally closed contacts that will open whenever a flow of cooling water of a user-settable amount is detected.
Instructions
Please follow these instructions to connect the 10271 to the NMEA 2000 network via a Maretron SIM100 Switch Indicator Module. The wiring diagram appears in Figure 1. The diagram shows a connection to channel #1, but connections to other channels are similar. Please refer to the original manufacturer’s instructions packaged with the product for additional details including setting of the switch activation flow rate.
1. Install the two wires from the 10271 to a free switch channel on the SIM100. The two wires are interchangeable. The example in Figure 1 shows the flow switch connected to switch channel 1, terminals SW1A and SW1B.
2. Use a Maretron DSM250 display (firmware 1.3.5 or higher), or the DSM250 Viewing function of Maretron N2KAnalyzer software, or other Maretron display product capable of configuring the SIM100 to set the switch channel mode (indicated as “Channel #x Mode” on the DSM250) for the appro priate channel to the “No End of Line Resistor” setting. For this example, you would set “Channel #1 Mode” to “No End of Line Resistor”.
3. Supply Power to the NMEA 2000 network, Verify that the switch channel indicates an “on” (normal) state using Maretron N2KView software, N2KAnalyzer, or other product capable of displaying switch indicator state.
4. Start cooling water flow through the 10271 and verify that the switch channel indicates an “off” state.
Flow Switch
1 2 5 4 3 6 7 8 9 10 11 12
SW1A SW2B
SW1B SW2A SW3A SW3B SW4A SW4B SW5A SW5B
SW6A SW6B
Figure 1 - Wiring Diagram
SIM100 Screw Terminals
Copyright © 2011 Maretron, LLP All Rights Reserved P/N: M003017 Rev.1.1 7/11
Device Specifications
Parameter Value
Inside Diameter 1.5” (38.1mm) Outside Diameter 2.22” (56.4mm) Length 4.36” (110.7mm) Height 3.08” (78.2mm) Activation Flow Rate W/O Baffle 10-14 GPM (37.9-53.0 LPM) Activation Flow Rate W/Baffle 6-8 GPM (22.7-30.3 LPM) Contacts Normally Closed Connections 1-1/2” FPT Female Switching Rating 50W Switching Voltage (Max) 300VAC / 300VDC Maximum Switching 0.5A (0.3A inductive) Heat Resistance, Continuous 210°F (99°C) Maximum Pressure 120 PSI @ 72°F
8.3 bar @ 22°C External Fasteners 18-8 Stainless Steel Construction CPVC Schedule 80 Connection 5’ (1.5m) Marine Grade Tinned Wire Leads Springs Hastelloy “C” Springs for Corrosion Resistance Gasket EPDM
For installation support, please contact:
Maretron, LLP
9014 N. 23rd Ave #10
Phoenix, AZ 85021-7850
Telephone: (+1) 866-550-9100
E-mail: support@maretron.com
Web: http://www.maretron.com
Copyright © 2011 Maretron, LLP All Rights Reserved P/N: M003017 Rev.1.1 7/11
Loading...