Mares VOLTREX, ABYSS DEALER MANUAL
DEALER
·
MANUAL
SECOND
STAGE
D
ABYSS/VOl
Disassembly
•
1.
Slide hose protector (46) away from second stage.
2. Using two wrenches (817) remove hose (26) from second stage.
3.
Remove hose connector assembly (28-29-21-27) from second stage using wrench (817).
4.
Remove o-ring (29) from hose connector (28).
5.
Using a 5 mm. alien wrench (84) remove the seat connector (21) and o-ring (27) from hose connector.
6.
Remove o-ring (27) from seat connector.
7.
Remove clamp ring screw (38).
8.
Expand the clamp ring (37) until it will slide over the flange of the second stage body.
9.
Remove the second stage purge cover (39), diaphragm (36) and clamp ring (37).
TREX
SECOND
STAGE SERVICE
NOTE
DISASSEMBLY
NECESSARY,
PURGE
IS
COMPONENTS.
10.
BUTTON· DOES NOT RETURN TO ITS NORMAL POSITION. UNLESS EXTREME CARE
TAKEN,
Remove lock nut (33), washer (34) and demand lever (35) using tool (812).
OF
THE
UNLESS
REMOVAL
PURGE
THE
OF
COVER
THE
PURGE
COVER
IS
SEVERELY
(PURGE
BUTTON
BUTTON,
ENCRUSTED,
MAY
SPRING
CAUSE
DIRTY
NOTE
THE
POPPET
WITH
WHEN THE
YOUR HAND TO
11. Remove poppet body
12. Remove poppet seat (47) from poppet body.
13. Remove exhaust tee (41) from second stage case.
14. Remove exhaust
15. Remove mouthpiece clamp (43) by cutting it with an appropriate tool.
16. Remove mouthpiece (44) .
BODY (30) IS UNDER SPRING TENSION. COVER THE
LOCK
PREVENT
NUT
IS REMOVED.
(30) and spring (31) from second stage inlet.
valve (40).
THE POPPET BODY (30) AND SPRING (31) FROM BEING EJECTED
SECOND
AND
OR WHENEVER THE
DAMAGE
STAGE INLET FITTING
COVER)
TO
THE
IS
NOT
COVER
•
CLEANING
Cleaning requires all reusable rubber and plastic parts to be carefully cleaned by scrubbing with a soft brush
in a
mild detergent and water solution. Do not use solvents or acids on rubber
should be cleaned in an ultrasonic cleaner with fresh water
with warm water is recommended). 8efore reassembly make sure all parts have been carefully rinsed and
dried.
A
PROTECT EYES AND SKIN ADEQUATELY WHEN WORKING WITH ANY KIND OF ACID. BEFORE
CLEANING METAL PARTS, MAKE SURE
REMOVED.
ACIDS OR OTHER SOLVENTS MAY DAMAGE RUBBER AND PLASTIC PARTS.
WARNING
THAT
ALL RUBBER AND PLASTIC PARTS HAVE BEEN
or
a mild acid solution. (White vinegar diluted
or
plastic parts. Metal parts
Loading...