Marcy E7000D User Manual

ELLIPTICAL TRAINER

PRODUCT CODE: E7000D

Escalade International Limited

Pleasant Road, Penllergaer, Swansea. SA4 9GE

Tel: [phone] Fax [phone]

www.escaladesports.co.uk

[e-mail]

Important Safety Information 3
Weight Limit Capacities

Exploded Diagram 5

Parts List 6

Parts Identifier 7

Assembly Instructions 8 - 11

User guide 12

Computer 13

Principles of Exercise 15

Fault Finding Chart 17

Additional Information 17

Warranty & Ordering Parts 18

Maintenance & Specifications 18

Supplied by

Escalade International Ltd

Pleasant Road

Penllergaer

Swansea
SA4 9GE

Tel: [phone]

Fax: [phone]

www.escaladesports.co.uk

E mail: [e-mail]

2

IMPORTANT SAFETY INFORMATION

READ ALL INSTRUCTIONS BEFORE USING

1. This elliptical is intended for class H (H=Domestic) use only. It is not designed for

2. This machine has been tested to BS EN 957 Parts 1:1996, 1+A1:1998 and 5:1996.

3. Read the OWNER’S OPERATION MANUAL and all accompanying literature and follow it

4. Keep children and pets away from the Elliptical at all times. Do not leave children

5. If children are allowed to use the Elliptical their physical/mental development and above all,

6. Position the Elliptical on a clear levelled surface which is clear of all obstacles as not to

7. Exercise equipment has moving parts. In the interest of safety, keep others, especially

8. Never hold your breath while exercising. Breathing should remain at a normal rate in

9. Rest adequately between workouts. Muscle tone develops during these rest periods.

10. Remove all jewellery, including rings, chains and pins before commencing exercise.

11. Always wear suitable clothing and footwear during exercise. Do not wear loose fitting

IMPORTANT!!! THE MAXIMUM RECOMMENDED WEIGHT CAPACITY FOR YOUR
ELLIPTICAL IS 150KGS.

THIS OWNER’S MANUAL CONTAINS ASSEMBLY, OPERATION, MAINTENANCE AND SAFETY

INFORMATION. IN THE INTEREST OF SAFETY, PLEASE MAKE CERTAIN THAT YOU READ

AND UNDERSTAND ALL THE INFORMATION BELOW.

commercial use.

carefully before using your elliptical.

unattended in the same room with the Elliptical. The Elliptical is not a toy and therefore
parents and guardians should be aware of the natural tendency for children to play, leading
to situations and behaviour for which the Elliptical is not intended.

temperament should be taken into account. Constant supervision is therefore needed.

restrict movement whilst exercising. DO NOT use the Elliptical near water or outdoors.

children, at a safe distance while exercising.

conjunction with the level of exercise being performed.

Beginners should work out twice a week and increase gradually to 4 to 5 times per week.

clothing that could become entangled with the moving parts of your exercise machine.

3

OUR ELLIPTICALS ARE MANUFACTURED WITH CARE AND ATTENTION. QUALITY AND CUSTOMER
SATISFACTION ARE OUR MAIN AIM. HOWEVER THINGS MAY GO WRONG. IF YOU SHOULD HAVE ANY
PROBLEMS OR FIND YOU HAVE PARTS MISSING, PLEASE CONTACT ESCALADE DIRECTLY.

HOWEVER, THERE MAY BE EXCEPTIONAL CIRCUMSTANCES WHERE YOU MAY WISH TO RETURN THE
ELLIPTICAL. WE THEREFORE ASK THAT YOU RETAIN ALL PACKAGING UNTIL YOU ARE COMPLETELY
SATISFIED.

NOTE: SOME ITEMS OF HARDWARE MAY ALREADY BE PRE-ASSEMBLED ONTO YOUR ELLIPTICAL.

WARNING: Before commencing any exercise program, please consult your family
physician. If at any time during exercise you feel faint, dizzy or experience pain, stop and
consult your family physician. In the event any of the above mentioned warnings are
breached by the consumer, the manufacturer may use same as a defence to any claim for
injuries, damage or loss. The above warnings are in no way intended to limit or modify the
consumer’s remedies for breach of warranties. They are being supplied strictly to ensure
the safety of the individuals using this product.

IMPORTANT: Read all instructions carefully. Assemble the Elliptical in

accordance with the steps in the manual. Box spanners and an allen key
are included for assembly. Lay out all parts on the floor. Make sure that
you have all the parts listed below before beginning assembly. In case of
discrepancy, please call our Customer Service Department at the number
listed on page 18 of this manual.

4

EXPLODED DIAGRAM

5

PARTS LIST

4

4

4

2

2

PART
NO,

1 REAR STABILIZER 1 PCS

2 ADJUSTING CAP 2 PCS 42 DISC FOR COVER 2 PCS

3

4 ACORN NUT 8 PCS 44

5

6 FRONT STABILIZER 1 PCS 46 PEDAL ARM ( LEFT ) 1 PCS

7 TRANSPORTATION WHEEL 2 PCS 47 COMPUTER CABLE UPPER 1PCS

8 HANDLEBAR POST 1 PCS 48 BEARING FOR FLYWHEEL 1 PCS

9 COVER FOR HANDLEBAR POST 1 PCS 49 BUSHING FOR FLYWHEEL 1PCS

10 SCREW FOR HANDLEBAR POST M8*16L 4 PCS 50

11 MOVEABLE HANDLEBAR ( LEFT ) 1 PCS 51

12 MOVEAVLE HANDLEBAR ( RIGHT ) 1 PCS 52 GEAR BOX 1PCS

13 AXLE FOR MOVEABLE HANDLEBAR 1 PCS 53 COMPUTER CABLE LOWER 1PCS

14

15

16

17 PLASTIC CAP 4 PCS 57

18 ALLEN BOLT ( M8*55L) 2 PCS 58

19

20

21 LEFT HANDLEBAR 1 PCS 61

22 RIGHT HANDLEBAR 1 PCS 62 ACROSS BAR FOR DISC

23 FLAT WASHER

24 CARRIAGE BOLT ( M8*40L) 4 PCS 64 DRIVING BELT 1 PCS

25

26 HANDPULSE SET 1 SET 66 C TYPE RING FOR ACROSS BAR 1 PCS

27 FOAM FOR FIXED HANDLEBAR 1 PCS 67 MAIN FRAME 1 PCS

28 FIXED HANDLEBAR 1 PCS 68 SCERW FOR DISC 14 PCS

29 NUT FOR PEDAL ARM 2 PCS 69 SENSOR BOX 1 PCS

30 SCRW FOR FLYWHEEL 1 PCS 70 NUT FOR ACROSS BAR 2 PCS

31

32 LEFT FOOT PAD 1PCS 72 FLYWHEEL SET 1 SET

33 RIGHT FOOT PAD 1 PCS 73 MAGNETIC SET 1 SET

34 CARRIAGE BOLT ( M6*50L) 4 PCS 74 CAP FOR PEDAL ARM

35 FIXING KNOB 4 PCS 75 SCRWS FOR COVER M4x50L 2 PCS

36

37 COMPUTER 1 PCS 77

38 RIGHT CHAINCOVER 1 PCS 78

39 LEFT CHAINCOVER 1PCS 79 SMALL DISC FOR COVER 2 PCS

40 FRONT TRANSPARENT COVER 1 PCS 80 AC ADAPTOR 1 PCS

DESCRIPTION QTY PART NO, DESCRIPTION

1 REAR TRANSPARENT COVER 1 PCS

CARRIAGE BOLT FOR STABILIZER
M8*75L

CURVED WASHER ( ø8*2t)

TEFLON WASHER FOR MOVE( ø25*1t)

FLAT WASHER ( ø10*2t)

HEX BOLT ( M8*P1.0*20L)

NYLON LOCK NUT HANDLEBAR ( M8) 3 PCS

WASHER FOR MOVEABLE HANDLEBAR
φ 8xφ16x2t

ALLEN HEAD BOLT (M8*35L)

WASHER FOR FLYWEELφ 10xφ18x1t

FLAT WASHER FOR FIXING KNOB
ø6* ø16*2t

4 PCS 43

16 PCS 45 PEDAL ARM ( RIGHT ) 1 PCS

4PCS 54

4 PCS 55

2 PCS 56

4 PCS 60

1 PCS

4 PCS 65 BERAING FOR BIG PULLEY 2 PCS

2 PCS 71 ADJUSTOR FOR FLYWHEEL 2 PCS

4 PCS 76

59 NYLON NUT 3/8”*7T 2PCS

63

FOAM GRIP FOR RIGHT & LEFT
HANDLEBAR

WAVY WASHER φ 17.5xφ25x0.3t

METAL BUSHING 38.2mm

SCREWS FOR FIXING
COMPUTER M5*10L

RUBBER SLEEVE ø26* ø32*8.5L
( A )

SPRING WASHER FOR FIXING
HANDLE BAR ø8

WASHER ø17.5* ø25*0.3L

WASHER FOR DISC ø5* ø16*1T

SCREWS FOR COVER 3/16”

CAP FOR PEDAL ARM ø3*
ø32*13.5L (B)

SPRING WASHER FOR PEDAL
ARM ø6

BIG PULLEY ø289*9

SCREWS FOR FIXING COVER
(M4*20L)

SCREW FOR FIXING REAR
COVER (M4*12L)

WAVY WASHER (ø20* ø30*0.3T)

2 PCS

4PCS

2PCS

4PCS

2PCS

PCS

2PCS

8PCS

8PCS

2PCS

PCS

PCS

1 PCS

PCS

2 PCS

6 PCS

1 PCS

6