Marco FILTRO SHUTTLE 5.6kW, FILTRO SHUTTLE 2.8kW Instruction Manual

mar coO

FI LTROSHUTTLE

MAINTEtiANCE:

Marco macnines have been designed to give many years of trouble free service.
Marco Beverage Systems design, manufacture and test to IS09001 :2000 standard.

The only regular ~aintenance required is occasional de-scaling.

In common with all water boiler manufacturers, service calls resulting from
limescale are not covered by warranty. Fitting a scale reducer is recommended,

especially in hard water areas. This can reduce the build-up of scale but may not

stop it altogether.

A service agent should descale the machine regularly. The frequency that

descaling is required depends on the local water supply; hard water areas need
more attention. Marco suggest that the machine be descaled every 3 months if the

unit is in a hard water area. In soft water environments every 6 months should
suffice.

CLEANING:

POURING

PERFECTION

Lil,e any :-:ooking utensils the coffee urns of your Filtro Shuttle must be cleaned
properly

8,.,rj regularly. Marco recommend cleaning after each days brewing using a

ProPI;etar. urn-cleansing compound.
MareI'

u", -::Ieans~"r (Marco Part number 8000240) is available in 800g tubs.

Instn'st... ., are givt:n~n each tub.

The e\ renul of these machines may be cleaned with a damp cloth and a light

dete'

]8;'1 Do not use abrasive cloths or creams, as this will spoil the finish of the

machh:; Do not use a water jet or spray. Beware of accidentally operating the
draw off

t"JP when cleaning the front of the machine.

URNS:

The

Ftro Shuttle is designed to accommodate the Marco urn

Parr

nurnl-,e: 1700174 Insulated Urn 6L Shuttle

INSTRUCTIONS FOR MODELS

FILTRO SHUTTLE 5.6~(VJ

(PIN: 1000650)

FILTRO SHUTTLE 2.8kW'

(PIN: 1000651)

Water Pressure: 5 - 50 psi (min.-max.)35 - 345 kPa (min.-max.;

Water Flow Rate: 1.5Litres per minute minimum

r

! MARCO h~::11

1509001 :2IJ!J,;

Registered

Cornpar,y

(i)

~ ~~(.'\~~ooo~

CE

Marco Beverage Systems Limited.
63d Heather Road,

Sandyford Industrial Estate,
Dublin 18

Ireland Tel: [phone]
lieland Fax: [phone]
email: [e-mail]

www.f!11Jr;;o.ie

Marco Beverage Systems Limite::!.
Shire House, Strixton Manor

Strixton, Wellingborough. No:than:;;
NN29 7PA

________________ J

UK Tel: [phone] ;
UK Fax: [phone]
email: sales@rnarcc-hp.v .. :.- Jk
www.marco-bev.co.uk

--- -- -~.-. --_ ..."...-------

Instructkp :iU·:'i 2;1Filtro Shuttle 29-J3-07.doc

Page 8 of 8

I 1.,_. __--

WARNINGS

FLOODING WARNING:

FLOODING DURIN BREWING- This machine MUST be positioned on a

counter with a drainage facility. The machine can be operated without a

basket or urn/receptacle in place which will cause water to spray/flow
directly onto the counter. All potential operators should be fully trained in
its correct use. The machine should always be set in the "Lock Mode" if it
is left unsupervised to prevent incorrect use.

PLUMBING- The hose supplied with this unit is non-toxic food quality tested

to 190psi. However, a hose is not a permanent connection. It is, therefore,

advisable to switch off the machine'and close the stopcock valve when the
machine is not in use, e.g. overnight, weekends etc. All plumbing should be
done by a qualified service engineer.

SCALDING- Beware of accidentally operating the water drawoff tap and

brewing buttons, especially when cleaning the front of the boiler. ALL users
of this machine should be trained and should be aware that the machine

dispenses very hot beverages/water.
ELECTRICAL- This appliance must be earthed!

A 5.6kW machine should be installed by a qualified electrician.
The utmost care has been taken in the manufacture and testing of this unit.

Failure to install, maintain and or operate this boiler according to the
manufacturer's instructions may result in conditions that can cause injury or

damage to property. If in any doubt about the serviceability of the machine

always contact the manufacturer or your supplier for advice.
SERVICE I MAINTENANCE -The utmost care has been taken in the

manufacture and testing of this unit. Failure to install, maintain and or
operate this boiler according to the manufacturer's instructions may result in
conditions that can cause injury or damage to property. If in any doubt about
the serviceability of the boiler always contact the manufacturer or your
supplier for advice.

TROUBLESHOOTING:
The Marco Filtro Shuttle uses an electronic diagnostic system to help determine

faults. If an error is detected a sequence of flashes is displayed through the

POWER light. This sequence is repeated (cycled) until:

1. The problem is rectified by a service agent, or

2. In the case of the 6 flash cycle - the machine senses that normal operation has
resumed, and the flash sequence ceases. '

The number of flashes in a cycle corresponds to the symptom in the table below.

Note: Two flash and six flash error sequences will be displayed if
there is low water pressure (above 5psi). Please check that there is
adequate water pressure and that the water stop-valve is open

before calling your service agent. Low water pressure errors can
also result from other machines taking in large volumes of water at

the same time e.g. dishwashers.

Status/Dia~:mostic Ii~ht ~uide:

No of

Symptom

Action required

flashes

Water level below elements.

2

Normal when machine first

Check water pressure, if this is

fills. May take 10-15 minutes

OK - call service agent.

to fill at low pressure

3

Temperature sensor failure

Call service agent

'ole)

4

Water not heating

Call service agent

5

Temperature sensor failure

Call service agent

(sic)

Check water pressure. If this is

6

Machine not filling

OK and the machine has not

returned to normal operation after

15 min - call service aaent

Instruction Booklet Filtro Shuttle 29-03-07.doc

Page 2 of 8

---------------------------------- -----

Instruction Booklet Filtro Shuttle 29-03-07.doc Page 7 of 8