Marantz SR5600, SR5500 user guide

Partner: Marantz
Model: SR5500
Device Type: Receiver/Processor

GENERAL INFORMATION

SIMPLWINDOWS NAME:

Marantz SR5500

CATEGORY:

VERSION:

SUMMARY:

GENERAL NOTES:

CRESTRON HARDWARE REQUIRED:

SETUP OF CRESTRON HARDWARE:

VENDOR FIRMWARE:

VENDOR SETUP:

Receiver/Processor

1.0

This module controls the Marantz SR5500.

This module provides controls for both zones of the SR5500. IT also provides true
feedback.

NOTE: IN THE PREFERENCES MENU, YOU MUST SET THE STBY MODE TO NORMAL.
IF YOU DO NOT CHANGE THIS SETTING, YOU WILL NOT BE ABLE TO TURN THE
RECEIVER ON VIA RS232.

CNXCOM, C2-COM, ST-COM

RS232

Baud: 9600

Parity: None

Data Bits: 8

Stop Bits: 1

None

IN THE PREFERENCES MENU, YOU MUST SET THE STBY MODE TO NORMAL. IF YOU
DO NOT CHANGE THIS SETTING, YOU WILL NOT BE ABLE TO TURN THE RECEIVER
ON VIA RS232.

CABLE DIAGRAM:

CNSP-123

Partner: Marantz
Model: SR5500
Device Type: Receiver/Processor

CONTROL:

power_on/off/toggle D Pulse to turn the main zone on or off.

source_* D Pulse to select the input.

source_m_ch_on/off D Pulse to turn the multi-channel input on or off.

input_ana/digi_digital_auto
input_analog/digital_fixed

Volume_Up/Down D Press and hold to adjust the volume up or down.

Volume_Mute_On/Off/Toggle D Pulse to turn the volume mute on or off.

volume_value(-72d_to_18d)

Volume_value_set D Pulse to send the volume level set by the volume_value input.

Attenuator_on/off/toggle D Pulse to turn the attenuator on and off. This is for analog audio signals only.

Bass_up/down D Press and hold to adjust the bass.

Treble_up/down D Press and hold to adjust the treble.

Video_mute_on/off/toggle D Pulse to turn the video mute on and off.

Display_* D Pulse to select the information you want displayed on the front of the receiver.

Sleep_*

D Pulse to set the input signal type to digital auto, digital fixed or analog.

A

D

Analog value for volume presets. Valid values are –72d to 18d. This should be
driven from an Analog Initialize. IT SHOULD NOT BE DRIVEN FROM A SLIDER.

Pulse to select the sleep time or turn the sleep timer off. Toggle will step through
the sleep times.

Night_mode_on/off/toggle D Pulse to turn the night mode on and off. This is for digital signals only.

Theater-EQ_on/off/toggle D Pulse to turn the home theater EQ on and off.

Menu_* D Pulse to use the set up menus.

Simple_Setup_* D Pulse to activate the simple set up function.

Surround_* D Pulse to select the surround mode.

Test_tone_* D Pulse to set the test ones for speaker set up.