Marantec D306, D313, D304, D321, E-KING 868 Programming Manual

http://www.remotecontrol-

express.com

MARANTEC

D302

Program

ming of your new remote control

1. Connect your already-

programmed remote control to

supplied clip (diagram above).

2. Press a button on your

old (or already

The LED light on your

old

3.

While keeping the button

wish to program on

your new remote control. Keep

new remote control blinks and then remains lit

4.

Repeat this procedure for each button you wish to program.

5. Wait 10 seconds.

6.

Your new remote control is programmed.

With the receiver :

ATTENTION:

Only use this programming method if you no longer possess any remote controls that

work. This programming method will erase all of your previously

1.

Press and hold down the button P until the LED light 2 blinks.

2. Press the b

utton P several times until the LED light 7 blinks.

Programming Manual

- TEL : [phone] - FAX :

[phone]

- D304 - D306 - D313 -

D321

E-KING 868 - 433

:

your new remote control

-programmed)

remote control. Keep it

remote control illuminates.

of your old

remote control pressed down, press

it pressed down. The LED light o

constantly. Let

the buttons

-

programmed remotes.

- D323 –

with the

pressed down.

the button you

n your

go.

http://www.remotecontrol-

express.com

3.

Press the button on your new remote control. The LED 7 blinks more quickly.

4.

Press the button P and then let it go.

5.

Your new remote control is programmed.

Programming Manual

- TEL : [phone] - FAX :

[phone]

Wait ten seconds.