Mantracourt T24-DWS, T24-WSSP Quick Start Manual

Wind Speed Sensor and In-Cab Display

Quick Start Guide

When bought as a set, the T24-DWS and T24-WSSP are

paired and will work as a system straight out-of-the-box

for ease of use!

2

Digit Mode Button

set point

Power Button

Up/Down Keys

Fast and Easy Setup

Simply put two D cell batteries in the wind speed sensor and apply
power (8-36 Vdc) to the display.

The display will automatically wake the
wind speed sensor when it is powered up
using the Power button and will sleep
when it is powered down.

You can change the measurement units by pressing the Digit/mode
button. This will cycle through metres per second (m/s) and miles per
hour (mph). There is a small enunciator at the bottom of the display
showing which units have been selected. The display will show the 10
second average wind speed at the default setting of once per second

Use this to change the
measurement unit.

Press and hold this button
to set the buzzer / relay

Used to change digits

Powering on and off wakes
and sleeps the wind speed
sensor

The buzzer/relay set point is set using the buttons on the display. Press
and hold the Digit/Mode button until all seven digits are shown.

Short presses on the Digit/Mode button selects the digit to change and
the up/down keys change the number. Press and hold Digit/Mode
again to save the changes. This is factory set to 55.9 m/s (125 mph)

3

Info

Save & Restore

Radio Settings
LQI

Advanced

Extra Configuration Options Using T24 Toolkit Software

In order to use the free T24 Toolkit software you need to pair the
device with the software. You will also need to connect a base station to
your PC.

Pairing the Toolkit to the Display (T24-DWS)

Download and open the Mantracourt T24 Toolkit from
mantracourt.com/software/t24-range

Remove the power source, click Pair and re-connect power source. The
DWS is detected and paired to the Toolkit.

There are various tabs in the Toolkit including the Info page, Save and

Restore, Radio settings and LQI.

The Advanced page allows us to view and set the paired data tag and ID
of the wind speed sensor.

Pairing the Toolkit to the Wind Speed Sensor (T24-WSSP)

Remove the power source, click Pair and re-connect power source. The
WSS is detected and paired to the Toolkit.

There are various tabs in the Toolkit including the Info page, Save and
Restore, Radio settings and LQI.

4