MantaroBot TeleMe 2 Quick Start Manual

MANTAROBOT™ TELEME 2

Assembly Instructions &

Quick Start Guide

20410 Century Boulevard  Suite 120  Germantown Maryland 20874

www.MantaroBot.com  [e-mail]

MantaroBot™

Phone [phone]  Fax [phone]

MANTAROBOT TELEME 2

Assembly Instructions &
Quick Start Guide

Table of Contents

Assembly Instructions ................................................................................................................................... 3

Quick Start ................................................................................................................................................... 10

20410 Century Boulevard  Suite 120  Germantown Maryland 20874

www.MantaroBot.com  [e-mail]

2

MantaroBot™

Phone [phone]  Fax [phone]

MANTAROBOT TELEME 2

Assembly Instructions &
Quick Start Guide

Assembly Instructions

1. Carefully unpack the contents in which your TeleMe 2 was shipped. DO NOT throw away the

shipping materials. Store them safely so they can be used to ship or transport your TeleMe in
the future.

2. Identify the parts in the picture below. The only tool required to assemble your TeleMe 2 is a #1

Phillips screwdriver.

MantaroBot™

20410 Century Boulevard  Suite 120  Germantown Maryland 20874

www.MantaroBot.com  [e-mail]

Phone [phone]  Fax [phone]

3

MANTAROBOT TELEME 2

Assembly Instructions &
Quick Start Guide

3. Protruding from bottom of mast (B) is a female connector. Protruding from top of base pole (A)

is a male connector. Plug female connector from mast (B) onto female connector of base (A).
See picture below.

4. Slide mast (B) over the base pole (A)

while aligning the two screw holes in
both (A) and (B). See picture on the
right.

20410 Century Boulevard  Suite 120  Germantown Maryland 20874

www.MantaroBot.com  [e-mail]

4

MantaroBot™

Phone [phone]  Fax [phone]

MANTAROBOT TELEME 2

Assembly Instructions &
Quick Start Guide

5. Using a #1 Phillips screw driver, screw two of the provided screws (D) into the bottom of mast

(B) to secure it to base (A). See picture below.

6. Protruding from bottom of device holder (C) is a female connector. Protruding from top of mast

(B) is a male connector. Plug female connector from device holder (C) onto female connector of
mast (B). See picture below.

20410 Century Boulevard  Suite 120  Germantown Maryland 20874

www.MantaroBot.com  [e-mail]

5

MantaroBot™

Phone [phone]  Fax [phone]