Manrose QF100S, QF100P, QF100T, QF100H, QF100TP Installation Manual

q u i e t

QF100S
QF100P
QF100T
QF100H
QF100TP
QF100TH

MANROSE

q

u

i

e t

INSTALLATION:

IMPORTANT NOTES:

(i) When installing a fan through an external wall, an external wall grille must be fitted at all times.
(ii) This fan must be installed by fixed wiring only. A flexible cord should not be used.
(iii) A double pole fused spur having a contact separation of at least 3mm in all poles MUST be used
and fitted with a 3A fuse.
(iv) For best results this extractor fan should be fitted at least 1.8 metres from the floor or if prefered in
the ceiling. Pullcord models are not suitable for installation in ceilings.
(v) Do not install the unit within a shower cubicle or anywhere else where there is a risk of being
sprayed with water (see our range of shower fans). Fan must be installed in the zone appropriate
to its IP rating (stated on the rating label) and level of circuit protection present. For further
guidance please refer to the zone diagram.
(vi) Switch off mains supply before making electrical connections. All installations must be in
accordance with building and wiring regulations, if in any doubt contact a qualified electrician.
(vii) This fan is double insulated and does not require an earth.

Please read these instructions before installation.

Switch off mains supply before making any electrical connections, if you are
in any doubt about the installation consult a qualified electrician.
This appliance may be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance. Cleaning and user
maintenance shall not be made by children without supervision.

Precautions must be taken to avoid the back-flow of gases into the room
from the open flue of gas or other open-fire appliances when mounted in
outside walls or windows.

Fan must be disconnected from electrical power before any maintenance or
adjustment is carried out.

Zone diagram for locations
with a bath or shower

1. Cut a 112mm (4

1/2

”) hole in the wall. If the fan is to be fixed in the ceiling ensure that the hole is

between the joists. Fit ducting flush to the plaster.

2. Remove the cover from the fan by removing the two small screw caps on the front cover and remove
the two retaining Philips screws.

3. Hold the body of the fan against the wall or ceiling and mark the four screw holes and cable entry.
IMPORTANT: Ensure the fan is square on the wall or ceiling.

4. Bring

power cable into position. Leave 230mm (9”) protruding to facilitate connection.

WINDOW

RECESS
ZONE0

~

'-

--

0-U_TS_ID_E_Z_O_N_

ES

___

CEILING

,-

OUTSIDE

ZONES

2.25M