Manrose DCT3208, DCT3209, DCT3211, DCT3212, DCT3640 Instructions Manual

PUB0164 iss:05 05/15

We reserve the right to change specification without notice

Manrose is proudly distributed by Simx Limited
PO Box 14 347, Panmure, Auckland, NZ. Technical Support [phone]
e: [e-mail] | www.simx.co.nz | www.manrose.com.au

Fixing clip

Ceiling board

Screw

Fan
chassis

When screw is tightened fixing
clip fingers secure the fan

Diagram 1
INSTALLATION

INSTALLATION INSTRUCTIONS

MANROSE 150MM
EXTRACT-A-LITE/EXTRACT-A-LED DIFFUSER

Please read all instructions before commencing installation.

LED models
DCT3208, DCT3209, DCT3211, DCT3212, DCT3640

Halogen models
DCT1169, DCT1171, DCT1521, DCT1522

Electrical
Supply

Driver Input: 220-240 VAC

Driver Output: 12VDC

Electrical
Supply

Transformer Input: 220-240 VAC

Output: 12VAC

Replacement
driver

FAN5342

Replacement
transformer

FAN2101

Lamp

MR16: 12V / 3W high power LED

Lamp

MR16: 12V / 50W Halogen

Replacement
lamp

LHT0221

Replacement
lamp

FAN0431

Please ensure the corrrect LED lamp and driver OR Halogen lamp and transformer are used for
replacements. The LED model MUST be replaced with an LED lamp and the Halogen model MUST
be replaced with a Halogen lamp. They are not interchangeable.

Installation Instructions

Important: The Halogen model Extract-a-Lite must not work independently of the fan.

1. Cut a 165mm diameter hole in ceiling, (always ensure the hole is cut between ceiling rafters and away
from any wiring or plumbing). Fix the chassis using the 4 screws provided. Use the fixing clips to secure
the grille (See diagram 1).

2. Connect the duct to the spigot of the chassis.

3. For the LED models: Connect LED driver to the Extract-a-LED and to a suitable power supply,
ideally to the switched live of the extractor fan installed. Recommended driver: FAN5342.
Replacement lamp: LHT0221

For the Halogen models: Connect a suitable transformer to the Extract-a-Lite and to a suitable
power supply, ideally to the switched live of the extractor fan installed. Recommended transformer:
FAN2101. Recommended lamp: FAN0431

4. Place the ceiling cover onto the chassis by locating onto the 3 lugs, and twisting clockwise.

5. Never connect mains direct to the lamps.

6. The transformer/driver must be suitable for 230V AC input.

CAUTION: Disconnect the power supply, and be sure that the lamp has fully cooled before removing
or replacing.

IMPORTANT

• Isolate the mains supply before making any electrical connections. This system should be
installed by a qualified electrician.

• When fitting through an external wall, an external grille must be fitted at all times.

• Fan should only be installed by fixed wiring, a flexible cord should not be used.

• The appliance is not intended for use by young children or infirm persons without supervision.

• Young children should be supervised to ensure that they do not play with the appliance.

• Precautions must be taken to avoid the back-flow of gases into the room from the open flue

of gas or other open-fire appliances when mounted in outside windows or walls.

Diagram 2
TYPICAL INSTALLATION

Internal
Extract-a-Lite/
Extract-a-LED

The Shower Fan to be hung
or screwed to the joist

External Grille

Flexible duct