Mannhart FP150 Installation Manual

FP150 FOOD PROCESSOR

MODEL FP150 ML-104600

701 S. RIDGE AVENUE

TROY, OHIO 45374-0001

937 332-3000

www.hobartcorp.com

F-33530 Rev B (August 2008)

PUSHER

FEED TUBE

LOCKING SCREW

CUTTING

TOOL

FEEDER/LID

WRENCH

PUSHER

PLATE

PUSHER

PLATE SHAFT

LOCKING KNOB

FP150 Food Processor

DICING GRID

EJECTOR
PLATE

TABLE OF CONTENTS

GENERAL ..............................................................................................................................................................3

INSTALLATION ......................................................................................................................................................3

Unpacking ........................................................................................................................................................3

Location ...........................................................................................................................................................3

Electrical Connections .....................................................................................................................................3

OPERATION ...........................................................................................................................................................3

Controls ............................................................................................................................................................4

Operations With A Single Plate — (Fig. 1) (Slicing, Shredding, Grating And Julienne Cutting) .......................4

Operations With Two Plates — (Fig. 2) (Dicing) ..............................................................................................4

Cutting Tool Guide............................................................................................................................................5

Using the Feed Hopper ....................................................................................................................................6

Using the Feed Tube ........................................................................................................................................6

CLEANING .............................................................................................................................................................6

MAINTENANCE .....................................................................................................................................................7

Replacement Dicing Grids ...............................................................................................................................7

TROUBLESHOOTING ...........................................................................................................................................8

Service .............................................................................................................................................................8

© HOBART, 2008

– 2 –

Installation, Operation and Care of

MODEL FP150 FOOD PROCESSOR

SAVE THESE INSTRUCTIONS

GENERAL

The Model FP150 Food Processor is used for slicing, shredding, grating, Julienne cutting and dicing
vegetables, fruits or cheese. The compact unit is designed for ease of operation and quick cleaning. A
wall rack and a wide range of slicer, shredder, and dicing plates are available options.

INSTALLATION

UNPACKING

Prior to installation, test the electrical service to ensure that it agrees with the specifi cations on the data
plate located at the rear. Immediately after unpacking the FP150, check for possible shipping damage.
If the food processor is found to be damaged, save the packaging material and contact the carrier within
15 days of delivery. Do not lift the food processor with any hinged or extended parts; lift only with one
hand under the protruding lip at the rear near the base of the motor compartment and the other hand
underneath the chute.

LOCATION

The FP150 should be operated on a suitable counter height surface. A pan (not provided), suitable for
kitchen use, can be used to capture the product at the exit chute.

ELECTRICAL CONNECTIONS

The electrical cord on this machine is equipped with a grounding- type plug which
must be connected to a properly grounded receptacle. If the receptacle is not the proper grounding
type, contact an electrician. Do not remove the grounding prong from the plug.

OPERATION

Rotating knives inside. Always use pusher plate. Keep hands out.

Proper assembly of the FP150, including selection of the appropriate cutters, is necessary for correct
operation of the food processor (Fig's. 1 & 2). Refer to the Cutting Tool Guide for sizes of cutters and
refer to the appropriate operation instructions.

– 3 –