Manley Laboratories Junior DAC Owners manual

MANLEY

LABORATORIES, INC.

MANLEY

REFERENCE

JUNIOR DAC

OWNER'S MANUAL

20 BIT DIGITAL TO ANALOG

CONVERTER

CONTENTS

SECTION PAGE

INTRODUCTION 3

MAINS CONNECTIONS 4

FRONT PANEL 5

REAR PANEL 6

OPERATIONAL NOTES 7

WARRANTY 8

WARRANTY REGISTRATION 9

NOTES 10



INTRODUCTION

THANK YOU!...

for choosing the Manley Reference Junior Stereo Digital To Analog Converter. The
Junior Digital To Analog Converter utilizes only the most modern componentry
including the decidedly best 20 BIT Ultra Analog (TM) system, precision 1% metal
film resistors, and highly regulated power rails.
Please take a few moments to read through this manual carefully as it contains
information essential to proper operation of this unit.

Thank you again, and please enjoy!

GENERAL NOTES

LOCATION & VENTILATION

The Manley Junior Stereo DAC must be installed in a stable location with ample
ventilation. It is recommended, if this unit is rack mounted, that you allow enough
clearance on the top and bottom of the unit such that a constant flow of air can

WATER & MOISTURE

As with any electrical equipment, this equipment should not be used near water or
moisture. If liquid enters the preamplifier, it must be immediately returned to your
deal for servicing.

SERVICING

The user should not attempt to service this unit beyond that described in the
owner's manual. Refer all servicing to Manley Laboratories.

WARNING!

!

TO PREVENT THE RISK OF ELECTRIC SHOCK

DO NOT OPEN THE CABINET

REFER SERVICING TO

QUALIFIED PERSONEL

MAINS CONNECTIONS

Your unit has been factory set to the correct mains voltage for your country. The
voltage setting is marked on the serial badge, located on the rear panel. Check
that this complies with your local supply.

Export units for certain markets have a moulded mains plug fitted to comply with
local requirements. If your unit does not have a plug fitted the coloured wires
should be connected to the appropriate plug terminals in accordance with the
following code.

GREEN/YELLOW EARTH terminal
BLUE NEUTRAL terminal
BROWN LIVE terminal

As the colours of the wires in the mains lead may not correspond with the coloured
marking identifying the terminals in your plug proceed as follows;

The wire which is coloured GREEN/YELLOW must be connected to the terminal in
the plug which is marked by the letter E or by the safety earth symbol or coloured
GREEN or GREEN and YELLOW.

The wire which is coloured BLUE must be connected to the terminal in the plug
which is marked by the letter N or coloured BLACK.

The wire which is coloured BROWN must be connected to the terminal in the plug
which is marked by the letter L or coloured RED.

DO NOT CONNECT/SWITCH ON THE MAINS SUPPLY UNTIL ALL OTHER
CONNECTIONS HAVE BEEN MADE.