Manitowoc Ice 7623123 User Manual

7623123 WATER CURTAIN SWITCH UPDATE KIT

USED ON G-1200 AND G-1700 SERIES ICE MACHINES

2 brackets, P/N 6268714

The water curtain spring, installed, will increase the return

The new switch activating bracket is made out of a lighter gauge

Kit Includes: 2 springs, P/N 3300113

strength of the water curtain switch arm.

stainless steel for easier mobility.

INSTALLATION INSTRUCTIONS:

1. Disconnect power supply.

2. Remove the left-hand side panel.

3. Remove the actuator retainers and switch activating brackets by removing the screws

supporting them (one in each, front and rear).

4. Remove the two screws supporting the switch mounting bracket and pull out the bracket

and switch assembly. Using needle-nose pliers, install the supplied springs into each water curtain switch (one in each, front and rear), as shown in Fig. 2.

5. Reassemble the bracket and switches in their original positions.

6. Replace the switch activating brackets with the new ones supplied (front and rear).

Reassemble the actuator retainers, with the new switch activating bracket, in their original positions. Note: All parts must be burr free.

7. Readjust the water curtain switches for proper operation, as necessary. See these

instructions on the inside of the front panel.

Manitowoc Ice, Inc.

2110 South 26th Street, P.O. Box 1720, Manitowoc, WI 54221-1720 USA Telephone 920-682-0161, Fax - Sales: 920-683-7589, Service/Parts: 920-683-7585, O ther: 920-683-7879 8003553 Web Site - www.manitowocice.com

Rev. 10/09/03