Manhattan Comfort 10GMC4 User Manual

Download

Page 1

Assembly Guide

1000010417 - 13/03/2019

Model: 10GMC1 / 10GMC2 / 10GMC3 / 10GMC4

Wide Cabinet

Stuck? Questions? We are here to help.

1-888-230-2225

help@manhattancomfort.com

Page 2

In order to ease the assembly, you should separate and identify the parts first

Do not place the parts directly onto the floor. Use a cardboard sheet or a mat to place the parts, during the separation and assembly.

IMPORTANT

In order to avoid severe or even fatal injuries, follow the

instructions carefully.

*Tools Needed (not supplied)

IDENTIFICATION OF PARTS

IDENTIFY THE COLOR OF YOUR CABINET

Dimension

N°

LEFT SIDE SMART

RIGHT SIDE SMART

CEILING 2 DOORS SMART

REAR 2 DOORS SMART

BACK 2 DOORS SMART

DOOR RIGHT SMART

DOOR LEFT SMART

FRAME SMART FRONT

FRAME SMART REAR

DESCRIPTION

BLACK MATT

3000009189

3000009202

3000009231

3000009214

3000009239

3000009349

3000009351

3000009224

3000009227

WHITE MATT

3000009322

3000009323

3000009328

3000009330

3000009348

3000009361

3000009363

3000009331

3000009333

BLUE MATT

3000009279

3000009280

3000009297

3000009284

3000009299

3000009300

3000009302

3000009292

3000009294

GREY MATERIAL

3000009243

3000009240

STEEL

QUANTITY

1 PC 15.35''

11PC

1 PC

LENGTH WIDTH THICKNESS

15.35''

27.48''

26.33''

26.25''

13.77''

27.51''

13.77''

13.70''

13.38''

12.16''

12.91''

14.01''

8.74''

0.66''

0.90''

1.29''

0.66''

1.37''

0.59''

Page 3

ASSEMBLED PRODUCT:

H: 20.07'' W:27.55'' L:13.77''

26 Lbs

26 LBS

Lbs

1000008297

Maximum weight supported distributed

Hardware list

1000008616

1000009033

1000000281 - WHITE

1000007352 - BLACK

1000010221 - BLUE

Qty. 2

1000010136

Qty. 2

1000008285

Qty. 4

Qty. 1

3000009645 - WHITE

3000009643 - BLACK

3000009649 - BLUE 3000009647 - GREY

Qty. 2

1000008285

Qty. 1

Page 4

1 - Identify the parts as figure below:

P8 with hole and P9 without hole

1 - Attach the P9 part on the P1 and P2 parts in the indicated direction. 2 - Then attachthe P8 part on the P1 and P2 parts.

Page 5

1 - Check the alignment of the holes on the fitted parts. 2 - The hole in the horizontal bar of part P8, should be up.

1 - With the F3 end, smash the safety grappel, locking the P8 and P9 part to the P1 and P2 part.

Page 6

1 - Identify the cutout on the top end of the P5 part. 2 - Attach the P5 part on the P1, P2 and P9 parts. 3- Slide part P5 to support on parts P1 and P2.

1 - With the end of F3, smash the safety claw, locking part P5 to part P1 and P2.

Page 7

1 - Attach the joint of the front of the P4 part under the P8 part. 2 - Lower the P4 part as indicated.

1 - Check all the fittings before moving forward.

Page 8

1 - Attach the P3 part on the parts P1 and P2.

2 - Pull the front of the P3 part.

Page 9

1 - With the F3 end, smash the safety grappel, locking the P3 part to the P5 part.

IMPORTANT: CABINET MUST BE ATTACHED TO THE WALL

1 - Lay the cabinet against the wall and mark the hole.

Page 10

1 - Drill the wall on the marked point, using a ½” drill bit.

½”

1 - Insert the metal part of the bushing into the hole until it overcomes the wall.

WALL

Page 11

1 - Pull the bushing driving it against the wall and then push the plastic ring until it leans close to the wall

Plastic ring

2 - Break the bushing's rods

WALL

Page 12

1 - Insert the screw F2 into the hole of part P5. 2 - Turn screw F2 with part F3 clockwise. 3 - Press part F4 against the heads of the F2 screws.

1 - Attach the F5 into the P8 part.

Page 13

1 - Attach the F7 handle to the doors P6 and P7 as indicated below

CLICK !

1 - Attach the F6 into the P6 and P7 holes.

Page 14

1 - Attach part P7 to the bottom of the cabinet through part F5 2 - Finish engaging part P7 through the pivoting wrench as shown below.

1 - Glue the sticker F8 in the lower right as indicated. 2 - Attach part P6 to the bottom of the cabinet through part F5 3 - Finish engaging part P6 through the pivoting wrench as shown below.

Page 15

TAKING GOOD CARE OF YOUR CABINET

Cleaning and caring instructions:

- Avoid dragging objects on top of the cabinet. They might scratch the ﬁnishing.

- Only non-abrasive natural chemical products are recommended to clean your cabinet. Simply wipe the cabinet down with a wet cloth to remove the cleaning product excess.

- Never clean the cabinet with scouring powders, steel scrubber pads or any other product which can scratch its surface.

- Chemical products are not recommended.

- Cabinet surfaces should not be covered with colored plastic or paper sheets.

- Acid substances like salt, onion, ketchup and mustard must remain properly stored in sealed containers.

- Avoid the direct contact of water with other surfaces than the sink, as the humidity can aﬀect the durability of the cabinets.

- Avoid cabinets exposure to direct Sun light. Drapers suggested.

- For technical assistance outside Brazil, please, contact the store where you purchased your product.

- This guidance should be saved for future reference, if necessary.

BEWARE: Do not use a damp cloth to clean the cabinet. Excessive moisture can damage its surface.

ATTENTION

To avoid serious or irreparable damage to the product, follow the instrucons carefully.

Page 16

WARRANTS TERMS

This product has the guarantee for a period of twelve (12) months, this limited warranty is eﬀective from the date of the original consumer purchase. Proof of original purchase date is required to obtain service or replacement under this limited warranty. Once the defect of manufacture has been veriﬁed, the consumer should contact the store where he purchased the product. In the warranty period, any defective parts will be replaced free of charge by another of the same line and model. The installation and assembly in the residence of the costumer is not the responsibility of the factory or the store. The assembly must correctly follow the instructions inside the packaging of each module.

ITEMS EXCLUDED FROM WARRANTS

This limited warranty does not cover:

1. In-home service including, but not limited to, service calls to correct the installation of any Manhattan Comfort Smart Diy products or to instruct the consumer on how to use or install them.

2. Damage resulting from improper handling or shipping of products, or products damaged by accident, alteration, misuse, abuse, ﬁre, ﬂood, improper installation, acts of God, neglect, corrosion, modiﬁcation or mishandling.

3. All travel, transportation, shipping or freight fees to deliver replacement products or to return defective products.

4. Factory speciﬁed replacement parts or product replacement when your product is used in other than normal, single-family household use, such as a commercial environment or handled in a manner contrary to published user or operator instructions and/or installation instructions.

5. Aesthetic damages including scratches, dings, dents or cracks that do not aﬀect the structural or functional capability of the product.

6. Any labor costs during the limited warranty period.

7. Damage resulting from improper loading beyond the speciﬁed maximum weight capacity outlined in the

assembly instructions provided with the product including overloading of hooks, baskets, shelves, cabinets, and other Manhattan Comfort Smart Diy accessories used with the product.

8. Surfaces damaged due to chemical interaction resulting in corrosion of paint or metal. The cost of repair or replacement under these excluded circumstances shall be borne by the customer.

DISCLAIMER OF IMPLIED WARRANTY

Implied warranties, including any implied warranty of merchantability or implied warrant of ﬁtness for a particular purpose, are limited to one year or shortest period allowed by law.

LIMITATION OF REMEDIES; EXCLUSION OF INCIDENTAL AND CONSEQUENTIAL DAMAGES

Your sole and exclusive remedy under this limited warranty shall be product repair as provided herein. Manhattan Comfort Smart Diy shall not be liable for incidental or consequential damages.

Stuck? Questions? We are here to help.

1-888-230-2225

help@manhattancomfort.com

Manhattan Comfort 10GMC4 User Manual

Specifications and Main Features

Frequently Asked Questions

User Manual