Page 1
MULTI-CARD
READER
WITH BUILT-IN
MULTI-MEDIA PANEL
USER
MANUAL
Model 702775
MAN-702775-UM-0308-01
Page 2
Thank you for purchasing the MANHATTAN® Multi-Card Reader with
Built-In Multi-Media Panel, Model 702775.
Compatible with most card formats (see Specications), this handy device
lets you easily download and transfer digital images without having to
directly connect the camera or other media device to the computer.
The easy-to-follow instructions in this manual help make installation of
the card quick and simple, so you’ll also soon be enjoying the benets
of these features:
• Convenient front-mount USB, FireWire, microphone and audio ports
• Supports Automatic Card Detection and data transfer speeds up to
480 Mbps
• Windows and Mac compatible; hot swappable; Plug and Play
• Lifetime Warranty
HARDWARE INSTALLATION
NOTE: The position and labeling of USB and other connector ports vary
among computer brands, which may require that you reference the
motherboard specications for clarication. Otherwise, use the images
and wire chart below for guidance.
1. Connect the
included cables to
the card reader.
(Each of the three
connections on the
reader will t only
the corresponding
cable connector.)
2. Mount the reader
into an available
5.25” bay, using
the included screws to secure it in place.
3. Install the included bracket on the back of the computer chassis.
4. Pull the FireWire and audio cables through the bracket and plug them in
to the corresponding ports on the back of the system.
2
Page 3
3 3
5. Once the multi-card reader
has been connected, turn
on the computer and install
the driver (for Windows
98SE only) as directed
below. For Me/2000/XP/
Vista, go to Conguration.
Right: Examples of how different
computer manufacturers may
label connectors corresponding
to specic cable wires. Also
shown is a typical dual-head
USB connection found on the motherboard.
NOTE: Normally, the connectors are labeled
on the board; if not, contact the manufacturer.
DRIVER INSTALLATION
NOTE: This procedure is for Windows 98SE only. For computers with
Windows Me/2000/XP/Vista, no additional driver installation is needed:
Go to Conguration.
1. When the card reader is
connected to a PC using
Windows 98SE before the
driver is installed, the Add
New Hardware Wizard
screen displays.
Click “Cancel.”
2. Insert the included
driver CD; then, in
the root directory,
double-click “AM_
Reader_98Drv_
Setup” to install the
driver.
Wire Connector Label
Red, orange POWER, VCC, SVCC, +5V
White, yellow P–, DATA–, SBD–
Green, gray P+, DATA+, SBD+
Black, blue, brown GROUND, GRND, GND
1 97
2
53
8
6
4
Page 4
44
3. Click “Multi-Media Panel”; click “USB 2.0 Multimedia Panel (USB +
Cardreader)”; click “USB 2.0 Cardreader (Alcor)”; then select the
Windows folder.
4. An “InstallShield Wizard Complete” message will display to indicate
the driver has been properly installed and that a reboot is required.
Click “Finish” to wrap up the procedure.
CONFIGURATION
With the Multi-Card Reader connected, there will be four Removable Disk
icons displayed. The disk drive letters (F:, G:, H: & I:, as shown in the
sample image) are determined by the PC’s conguration, which can vary;
however, the sequence of the removable disk drives is xed: SD family
(SD/MMC) rst, CF/MD second, SM third, MS Family (MS/MS Pro) fourth.
NOTE: Windows presents the option of installing a disk icon utility, which
replaces the generic Removable Disk icons with card-specic ones.
SD
CF
SM
MS
F
Page 5
5
1. Click on the Icon AP folder; click “AU6375 AP V1.23(PID6362)support
Multi_language”
to install the
utility.
2. Click through
the subsequent
status screens.
3. When the
InstallShield
Wizard Complete
screen displays,
select “Yes, I
want to restart
my computer
now.” Click
“Finish.”
OPERATING TIPS
• This Multi-Card Reader is a USB device designed to work under bus power mode; i.e., the power is drawn from a USB port and no power
adapter is required. Though a full 500 mA can be drawn from the USB
host to supply the card reader, during the initial enumeration stage only
100 mA from the host is available. To expedite and ensure the correct
USB enumeration process between the computer and the card reader,
it’s recommended that the card reader not be connected with cards
inserted in all four of the available slots.
Windows
98/Me/2000
disk icons:
Windows
XP/Vista
disk icons:
Page 6
• In addition to showing the four
Removable Disk icons on the
Exploring – My Computer
screen, when correctly
connected, the Multi-Card
Reader should display a USB
Mass Storage Device icon in
the Hardware Device Manager
folder. If there’s no Removable
Disk icon displayed in the
explorer’s window and the USB
Mass Storage Device icon in
Hardware Device Manager is
shown with a question mark (?),
it means the driver is not
installed or not ready. If the
reader’s slots are full of cards
while connecting to the PC,
remove the cards and try again.
Or, follow the aforementioned
procedure to install the driver and icon utility.
• If there is no Removable Disk icon in the explorer’s window and the
USB Mass Storage Device icon in Hardware Device Manager is shown
with an exclamation mark (!) or just reads “Unknown Device,” it means
the reader is not recognized by the PC and may be defective. Disconnect
the reader from the PC and re-connect it (reboot the PC and try again).
If nothing changes, the card reader is defective.
• If there is no icon displaying, or if there is no response from the PC
once the card reader is connected, the USB host of the PC may not
be working. Reboot the PC and try again. If nothing changes, the USB
host on the motherboard needs repair.
• Whenever possible, use the Safely Remove Hardware icon (on the
lower-right corner of Window’s task bar in the system tray area) to
stop the USB device rst before detaching it from a PC. This will
protect both the USB device and the PC.
6
Page 7
7
SPECIFICATIONS
Supports
CompactFlash Type I/II, Extreme CF, Extreme III CF, Ultra II CF, CF
High Speed, XS-CF, CF Elite Pro, CF PRO I/II, CF Picture, CF Wa,
CF UltraX*, IBM and Hitachi Microdrive, MagicStore, Memory Stick,
Memory Stick PRO, Memory Stick Duo*, Memory Stick PRO Duo*,
Memory Stick Extreme PRO, Memory Stick Extreme III PRO, Memory
Stick Ultra II PRO, MagicGate, MagicGate PRO, MagicGate Duo*,
MagicGate PRO Duo*, High Speed MagicGate PRO, High Speed
MagicGate PRO Duo*, High Speed Memory Stick PRO, High Speed
Memory Stick PRO Duo*, Memory Stick ROM, Memory Stick Select,
SecureDigital (SD), miniSD*, High Speed miniSD*, miniSDHC*, SDHC,
Extreme SD*, Extreme III SD, Ultra II SD, Ultra-X SD, Ultra Speed
SD, Pro SD, Elite Pro SD, High Speed SD, microSD, TransFlash*,
MMC/MMC II, RS-MMC*, High Speed MMC/RS-MMC*, Ultra RS
MMC*, DV-RS MMC*, MMCplus/100x/200x, MCCmobile, SmartMedia,
SmartMedia ROM and XD/Type M/Type H
* Adapter required (not included)
General
• Drivers, cable, bracket with screws and manual included
• Compatible with Windows 98SE/2000/Me/XP/Vista and Mac OS 9.X
or later
• Compliant with USB Specication Revision 2.0 and USB 1.1
• 1394a FireWire port
• 121.9 g (4.3 oz); 570 x 400 x 310 mm (22.4 X 15.7 X 12.2 in.)
Page 8
Copyright © MANHATTAN
All products mentioned are trademarks or registered trademarks of their respective owners.
www.manhattan-products.com
MANHATTAN® offers a complete line
of PC Components, Peripherals, Cables and Accessories.
Ask your local computer dealer for more information
or visit us online at
Loading...