BASIC INSTALLATION 
1. Insert the Multi-Card Reader into an available 3.5” bay and secure it in 
  place with the included screws.
2. Connect the two SATA cables  
  to the controller card; the USB  
  9-pin to the motherboard; and  
  the 4-pin pass-through.  
  NOTE: At right are examples of  
  how different computer manufacturers may label  
  connectors corresponding to specic cable  
  wires, plus a typical dual-head USB  
  connection found on the motherboard.  
  (Normally, the connectors are labeled on the 
  board; if not, contact the manufacturer.) 
3. No driver installation is required. Four ash memory card icons 
  (Removable Disks) will display in the My Computer les. 
SPECIFICATIONS 
SUPPORTED MEMORY CARD FORMATS 
C-Flash, CompactFlash Type I/II, Ultra II CF, MagicGate, MagicGate PRO, 
MagicGate PRO Duo, Memory Stick, Memory Stick Duo, Memory Stick PRO, 
Memory Stick PRO Duo, Memory Stick Select, Memory, Stick Extreme PRO, 
Memory Stick Extreme III PRO, Memory Stick Ultra II PRO Duo, Microdrive, 
DV-RS MMC, MMC / MMC II, MMC 4.0, MMCmicro, MMCmobile, MMCplus, 
RS-MMC, Ultra MMC, SecureDigital (SD), Elite Pro SD, Extreme SD, Kingmax 
SD, microSD / TransFlash, miniSD*, SecureDigital Ultimate, Ultra II SD and XD.
* Requires an adapter (not included)
Standards & Certications 
• USB 2.0; USB 1.1; SATA; CE; FCC
General 
• Internal connections: 2 SATA L-type 
 data (male), USB 9-pin (motherboard), 
 4-pin Molex pass-through 
• External connections: eSATA, SATA 
 data, SATA power and Hi-Speed 
 USB 2.0 port
• Throughput: Hi-Speed USB 2.0, up 
 to 480 Mbps; SATA, up to 3.0 Gbps
• LED power and activity indicators
• Windows 2000/XP/Vista compatible 
Physical 
• Fits in 3.5-inch drive bay
• 102 x 105 x 25 mm (4 x 4.13 x 1 in.)
• Weight: 267 g (9.4 oz.)
Wire  Connector Label
Red, orange  POWER, VCC, SVCC, +5V 
White, yellow  P–, DATA–, SBD– 
Green, gray  P+, DATA+, SBD+ 
Black, blue, brown  GROUND, GRND, GND
1 97
2
53
8
6
4