Mandolyn Electronic Technology TR430 Users Manual

OWNERS MANUAL

Congratulations on your purchase of a UPM slim remote control transmitter.

This unit is specifically designed to work with UPM brand receivers.

Please take the time to read and understand this manual so you can begin to enjoy the convenience this product can offer.

FEATURES

! 433 MHz RF technology

! Intelligent code learning

! Control up to 4 remote

receivers

! Ultra-slim design with

flush wall-mount bracket

! Master On/Off

! Transmission range of

up to 40 meters in open area

TR430 remote control transmitter

TR430 Transmitter

GETTING STARTED

remove the battery cover from

the back of the transmitter

place two button cell batteries

between terminals observing proper polarity then replace cover

the green LED will light up

with any key press once the battery is installed correctly

LED Indicator

Channel 1 ON Channel 2 ON Channel 3 ON Channel 4 ON

ALL ON

battery installation

button descriptions

Channel 1 OFF Channel 2 OFF Channel 3 OFF Channel 4 OFF ALL OFF

LEARN FUNCTION

The learn function must be performed to allow the receivers in your system to recognize the transmitter. More than 4,000 code combinations eliminate the possibility of interference by other transmitters.

Plug receiver into wall socket

Press LEARN on receiver while

simultaneously pressing the desired channel button on the transmitter

Repeat and for any additional

receivers (available at your local retailer) using available channels

If LEARN completed successfully,

the LED on the receiver should light up when ON is pressed

Note that a generic model of receiver is used for illustration here. Please

refer to the accompanying owners manual for the operations of your specific receiver.

ON/OFF

UPM

LEARN

REMOTE CONTROL RECEIVER

ON/OFF FUNCTION

Turn each receiver On/Off

individually by using the channel On/Off keys on the transmitter

MASTER ON/OFF

If you have more than one receiver set up, you can use the Master On/Off function to simultaneously turn ALL the receivers (of the same house code) On and Off at the same time.

Turn all receivers On or Off at

the same time by using the ALL ON / ALL OFF button

TROUBLESHOOTING

problem solution

Transmitter stops turning receiver on and off.

Use the LEARN function to reprogram the receiver or Check the battery

TECHNICAL SPECIFICATIONS

Battery Type: 2 x 1.5V button cell System Source: 4,096 code combinations Transmission Frequency: 433 MHz Transmission Range: up to 40 meters in open area

NOTICE

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Warning:

Changes or modifications made to this equipment not expressly approved by the manufacturer may void the FCC authorization to operate this equipment.