
Deluxe Kayak KitDeluxe Kayak Kit
SOFT RACK KAYAK CARRIER
Kayak Blocks
Installation & Loading Instructions - Please Read Before Beginning
1
. Place the kayak onto the Blocks so that it
is aligned and the weight of the kayak is
evenly distributed on each Block.
See image 2.
12’ Bow & Stern Lines15’ Load Straps9’ Block Straps
Step 1: Attaching Blocks to Kayak
. Unroll the 9’ Block Straps. Thread each one
through the cut-out in the bottom of each
Block. For installation without cross bars,
the Blocks should be placed so that they are
spaced apart 1/3 of the total length of the
kayak. For installation with cross bars, the
Blocks should be spaced apart the same
distance as the distance between the front
and rear cross bars. See image 1.
2
3
. Tighten the two Block Straps so that kayak
and Blocks are firmly cinched together.
See image 3.
MPG152

4
Installation & Loading Instructions - MPG152 Deluxe Kayak Kit
Step 2: Loading the Kayak
. Confirm that the bottom of the Blocks and
the roof of the vehicle are clean and free of
any dust or dirt that could scratch the finish.
Place the kayak with Blocks onto the vehicle.
For installation without cross bars, center the
kayak on the roof and confirm that the weight
is evenly distributed. See image 4.
Note: Do not place Blocks on sun roof.
For installation with cross bars, the Blocks
should be fitted onto the cross bars with the
bottom cut-outs fully inserted over each bar.
. Unroll the green 15’ Load Straps. Open
the vehicle’s doors. Throw the non-buckle
ends of each Strap up and over the kayak
and down to the other side of the vehicle.
The Straps and the Blocks should be as
closely aligned as possible. See image 5.
6
5
. With the doors open, pull both ends of the
straps together and buckle from the inside
of the vehicle. Confirm the straps are tight
and secure. See image 6.

Installation & Loading Instructions - MPG152 Deluxe Kayak Kit
7
. Install the bow and stern safety tie-downs
per the attached instructions.
13
Always check mounting hardware, load straps and safety tie-down lines for proper
and secure attachment before transport. Use of this product for any other
application other than kayak transport voids warranty.
Limit transport distance to 250 miles or less. Warning, this product is not
to be used as a flotation device.
Proudly Made In The USA
Warning: All vehicular rooftop transports are potentially hazardous.
Any person using MALONE automotive transport systems is personally
responsible for following the given directions for use and installation
and accepts full and complete responsibility for any and all damages
or injury of any kind including death, which may result from their use.
MALONE AUTO RACKS, 81 County Road, Westbrook, Maine 04092
Phone: 207-774-9100 Fax: 207-615-0551
Website: www.maloneautoracks.com Email: technical@maloneautoracks.com

MPG370 BOW & STERN LINE KIT
Attach hook to rope (steps A-D)
A B C D
Thread free end
of cord through
hook.
Create a “left
over right”
knot & tighten.
Create a “right
over left”
knot & tighten.
Pull to test for
knot strength.
Attach and dress rope to vehicle and boat (steps E-O)
Attach S-hook to vehicle
tow ring or other sturdy
body part.
Pass the loop through the
opening.
E
Keeping the rope tight and
S-hook in place, thread the
free end up and through a
strong point on the kayak
I
Pull to create a tight knot.
M
F
Make a loop in the rope
12” to 14” away
from the kayak or canoe.
J
Thread the free end of
the rope
through the loop.
N
G
K
Opening
Bend the loop over leaving
a large opening as shown.
Pull the free end up until
the rope
is sufficiently tight.
O
H
L
Hold the rope secure with
one hand.
MALONE AUTO RACKS, 81 County Road, Westbrook, Maine 04092
Website: www.maloneautoracks.com Email: technical@maloneautoracks.com
Form a knot with the free
Phone: 207-774-9100 Fax: 207-615-0551
end and tighten. Form
a second knot for
safety purposes.
The line should be tight
and secure. Repeat for
second tie-down.

Limited One Year Warranty
The Malone Auto Racks (Malone) Limited One Year Warranty covers certain Malone-brand products that have been specically
identied for inclusion in the program and is eective for one year from the date of purchase for the original retail purchaser.
This warranty is terminated after one year from the date of purchase, or, when the original retail purchaser sells or otherwise
transfers the product to any other person or entity during the one year warranty period.
Subject to the limitations and exclusions described in this warranty, Malone will remedy defects in materials and/or
workmanship by repairing or replacing, at its option, a defective product without charge for parts or labor. Malone may
elect, at its option, not to repair or replace a defective product but rather issue to the original retail purchaser a refund
equal to the purchase price paid for the product, or credit to be used toward the purchase of a replacement Malone
product.
This warranty does not cover, and no warranty is given for defects or problems caused by normal wear and tear which
includes but is not limited to surface (aesthetic) metal corrosion, scratches, dents, deformities, accidents, unlawful
vehicle operation, or any modication of a product not performed or authorized in writing by Malone.
In addition, this warranty does not cover problems resulting from conditions beyond Malone’s control including, but not
limited to, theft, misuse, overloading, or failure to assemble, mount or use the product in accordance with Malone’s
written instructions or guidelines included with the product available to the original retail purchaser.
No warranty is given for Malone products purchased outside of the United States, Canada and Mexico.
If the product is believed to be defective, the original retail purchaser should contact the Malone dealer from whom it
was purchased, who will give the original retail purchaser instructions on how to proceed. If the original retail purchaser
is unable to contact the Malone dealer, or the dealer is not able to remedy the defect, the original retail purchaser should
contact Malone by email at technical@maloneautoracks.com.
In the event that the product must be returned to Malone, a technician at the email address above will provide the
original purchaser with return shipping instructions. The original purchaser will be responsible for the cost of mailing
the product to Malone. In order to receive any remedy under this warranty, a copy of the original purchase receipt,
a description of the defect and a return address must be provided.
Disclaimer of Liability
Repair or replacement of a defective product, or the issue of a refund or credit (as determined by Malone) is the original
retail purchaser’s exclusive remedy under this warranty. Damage to original purchaser’s vehicle, cargo, or property, and/
or to any other person or property is not covered by this warranty.
This warranty is expressly made in lieu of any and all other warranties, express or implied, including the warranties of
merchantability and tness for a particular purpose.
Malone’s sole liability is limited to the remedy set forth above. In no event will Malone be liable for any direct, indirect,
consequential, incidental, special, exemplary, or punitive damages , or, for any other damages of any kind or nature
(including but not limited to, lost prots, lost income or lost sales).
Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitations
may not be applicable. This warranty gives you specic legal rights and you may also have other rights which vary from
state to state.
In addition, all vehicular transports are potentially hazardous. Any person using MALONE products are personally
responsible for following the given directions for use, installation and accepts full responsibility for any and all damages
or injury of any kind including death, which may result from their use.
MALONE AUTO RACKS, 81 County Road, Westbrook, Maine 04092
Phone: 207-774-9100 Fax: 207-615-0551
Website: www.maloneautoracks.com Email: sales@maloneautoracks.com