Malone MPG106MD User Manual
MALONE
R
TM
AutoLoader Kayak Carriers 12’ Load Straps
Installation & Loading Instructions - Please Read Before Beginning
1
AutoLoaderAutoLoader
J-STYLE KAYAK CARRIER
50mm
60mm
Jawz Universal Adapters
Step 1: Installing Carriers to Cross Bars
. Insert a Mounting Bolt into one of the top
side hex holes. See image 1.
Mounting Bolts
Rubber Plugs
T-Knobs
12’ Safety Lines
MD Series Only
. Insert Mounting Bolt through one hole
of a Jawz Mounting Adapter and loosely
apply a T-knob. See image 2.
3
. Place the carrier onto the front cross bar with
the boarding ramp facing out. Swing the Jawz
under the cross bar as shown. See image 3.
2
MALONE
R
Installation & Loading Instructions - MPG106M (MD) AutoLoader
4
. Insert a second Mounting Bolt into the top
side unused hex hole and down through the
Jawz mounting adapter. Apply a second
T-knob and slightly tighten until the carrier
is secure. Repeat steps 1-4 for the 2nd
carrier and rear cross bar. See image 4.
. Confirm the carriers are in alignment.
Firmly tighten the T-knobs until both
carriers are securely fixed to the cross
bars. See image 5.
TM
5
6
. Insert the four Rubber Plugs into the four
top side hex holes in the two carriers. See
image 6.
Step 2: Loading the Kayak
. Route the free end of a 12’ Load Strap
through the rear of the top strap slot in
the top of the carrier. Pull the free end
down until there is an even loop. Repeat
for the second carrier. See image 7.
7
Loading...