Mallory Ignition ACCEL 151308 User Manual

BATTERY ELIMINATOR

PART NO. 151308

For use with Magneto and Generator systems only. Use ACCEL solid state regulators 201103,
201104, or 211104.

When installing ACCEL’s battery eliminator on a Harley Davidson that originally utilized a battery-less
ignition system, it is recommended to mount the new unit to the original location, attaching the
wires as originally connected.

If installing the Battery Eliminator on a Harley-Davidson that was originally equipped with a
battery-operated system, it is recommended to mount it to the battery box as follows:

1) Drill a 3/16” hole in the center of the battery box.

2) Fit the battery eliminator in the shock resistant cushioned clamp and mount to battery
box with the enclosed self-tapping screw and grommet.

3) Once the Battery Eliminator is mounted, connect the positive wire from the ignition
switch (normally red) to the positive (+) terminal of the Battery Eliminator and connect
a wire from the negative (-) terminal of the Battery Eliminator to a good ground such
as the motorcycle engine or frame.

F

SWITCH

+

RED

REGULAT OR

BATTERY

A

ELIMINAT OR

ACCEL MOTORCYCLE IS A DIVISION OF PRESTOLITE PERFORMANCE
10601 MEMPHIS AVE. #12, CLEVELAND, OH 44144

216.688.8300 FAX [phone]

www.accel-motorcycle.com

FORM 3-582-87

12/07

Printed in U.S.A.