Mallory Ignition 25758M User Manual
25758M MAGNETO POINTS
Hold 4 pin driver on bottom of magneto head and remove lock nut, as seen on diagram. Now
remove lock washer, rotor drive plate and grease point cam. Next, install 5/16 AN washer, followed
by drive plate, lock washer and lock nut. Install #8 black washers on rotor screws. Be sure to
adjust point to .016”. Double check this gap after about 30 minutes of running time.
FORM 1646 03/05
INSTALLATION INSTRUCTIONS
www.malloryracing.com 1
MALLORY IS A DIVISION OF THE MR. GASKET PERFORMANCE GROUP
10601 MEMPHIS AVE. #12, CLEVELAND, OH 44144
216.688.8300 FAX 216.688.8306
FORM 1646
03/05
Made in U.S.A.
Printed in U.S.A.
ADD #8 BLACK WASHER
ADD #8 BLACK WASHER
LOCK NUT
WASHER
SCREW ( 2 REQD )
ROTOR
RH 28995
LH 28995A
OR
29038 ROTOR ADAPTER
ASSY, ROTOR DRIVE PLATE
ADD 5/16 AN WASHER
GREASE POINT CAM
SCREW (4 REQD)
25758M MAGNETO POINT
Loading...