Rechargeable Flashlight
MODEL
ML900
INSTRUCTION MANUAL
Power source Bulb Switch
Makita battery cartridge
(rechargeable Nc-cdl
9000
9 6 V Rocker type
500
mA
ON-OFF
Dimensions Net weight
0
84
mm
x
273
(0
3-114" x 10
mm
314")
IO
260
6
g
Ibsl
Installing
NOTE
Before operation, charge the battery cartridge with Makita
charger.
To
out the
on the battery cartridge with the
groove in the flashlight handle and
slip it into place. Snap the set plate
back into place. Be sure to close the
set
light.
or
removing battery cartridge
:
insert the battery cartridge, pull
set
plate, align the tongue
plate fully before using the flash-
9.6V
Fast
Switch
To
"ON" side of the switch.
Press the
Condensina or disDersina liaht
To
so
the knob
to the
Stand
The stand allows the flashlight to
be positioned
ward angle.
action
turn the flashlight on, press the
"OFF"
cast
a
that the pointer points to the
marking.
a
narrow spotlight beam, turn
For
=w
side to turn
-
wide beam, turn the knob
so
that the pointer points
marking.
at
--
a
convenient up-
it
off.
2
MAINTENANCE
CAUTION
Always
is
removed before attempting to perform inspection or maintenance.
:
be sure
that
the
flashlight
is
switched off and the battery cartridge
Replacing
Turn the ring counterclockwise and
remove the ring, reflector and bulb
together. Pull the bulb holder out
of the reflector. Pull the bulb out
of
bulb slightly clockwise.
To install a new bulb, follow the removal procedure in reverse. There
are three notches in the bulb holder.
Set the bulb in the center notch.
CAUTION
0
Replacement light bulbs are readily available from your Makita dealers,
or Makita Authorized or Factory Service Centers. Always specify bulb
type
*Never attempt to short the bulb
light
bulb
the bulb holder after turning the
:
(9.6
V,
500
mA).
I
I
rr
Set
the
bulb
here.
Bulb
holder
I
3
Cleaning
Use a cloth dampened in a mild detergent to clean off the flashlight from
a
time to time. Then wipe dry with
volatile agents will damage the plastic,
To
maintain product SAFETY and RELIABILITY, repairs, maintenance
and adjustment should be perfomed
Service Centers, always using Makita replacement parts.
OPTIONAL ACCESSORIES
The accessories listed in this manual are available at an extra cost from your
Makita Distributor or Makita Factory Service Center. Service centers are listed
on the warranty card packed with your tool.
dry cloth. Benzine, thinner and other
so
never use them.
by
Makita Authorized or Factory
Signal cap
Lanyard set
Strap
Recycling the battery
The only way
The law prohibits any other method of disposal.
To
recycle the battery:
1.
Remove the battery from the tool.
2.
(a) Take the battery to your nearest Makita Factory
(b) Take the battery to your nearest Makita Authorized
MC A-4193 883565CO67
to
dispose of a Makita battery is to recycle it.
Service Center.
or
Service Center or Distributor that has been designated as a Makita
battery recycling location.
Call your nearest Makita Service Center or Distributor to determine
the location that provides Makita battery recycling. See your local
-
yellow pages under ‘Tools
Makita Corporation
Electric.
Buford,
GA
”
of
America
@
Ni-Cd
I
PRINTED IN
USA
1995-8-4D
Loading...