Major tech LHS100 Operating Instructions Manual

LHS100

Rechargeable High-Power LED Spotlight

(Cordless)

Operating Instructions

Safety Instructions

Keep out of reach of children
Store in a clean and dry environment
Do not use if this unit is damaged in any way
Never short the terminals of the internal battery together
Never attempt to change the bulb when the battery is charging
Never look directly into the light

Caution!!

The lens will become hot after prolonged use
Do not attempt to disassemble the battery or remove any parts from the battery

terminals

Before disposing, protect exposed terminals

Charging the Internal Battery

1. The internal battery should already be charged at the time of purchase, however,

you should give the battery a top-up charge as soon as possible.

2. The internal battery should only be charged with one of the accessories provided

3. The spotlight must be in the OFF position whilst charging.

4. The spotlight should be kept fully charged when not in use. If it is stored then it

should be recharged every 10 – 12 weeks. Always ensure that the switch is in the
OFF position when it is not in use.

5. If the battery is fully depleted, the battery will take approximately 6 – 7 hours to

reach maximum capacity when using the supplied mains adapter.

6. The battery will also charge from the 12 volt cigarette lighter socket of your vehicle

using the lead provided. It is recommended that it is not left in this mode of
charging for longer than 2 hours (for emergency charging only). Charging should be
done with the engine running to prevent running down the charge on your vehicles’
battery.

7. The red LED will illuminate when the spotlight is receiving a charge but does not

indicate when the battery is fully charged.

Using your Cordless Rechargeable Spotlight

SPOTLIGHT OPERATION: (FIG.1):

To operate the main beam, press trigger 1
For prolonged or hands free operation hold in trigger 1 and
lock the switch 2 to the bottom position.

FLUORESCENT LIGHT OERATION (FIG.2):

To operate the fluorescent light press button 1, that is
located at the back of the lamp.

Working Time

Under optimum conditions, with a full charge, the

1W LED model, can normally be used for 2 hours.

The fluorescent model can normally be used for 8

hours.

Battery: 3.6V 600mA Ni-MH battery
AC adaptor: 6V 300mA

FIG.1

FIG.2