IntelliCAT
Windows 7 Recommended Power Options Settings
Installation User Support
March 26, 2014
Manual Part
99875669-1.01
REGISTERED TO ISO 9001:2008
MagTek I 1710 Apollo Court I Seal Beach, CA 90740 I Phone: (562) 546-6400 I Technical Support: (888) 624-8350
www.magtek.com
Document
Number:
Copyright © 2014 MagTek, Inc.
Rev Number
Date
Notes
1.01
March 21, 2014
Preliminary Release
Printed in the United States of America
Information in this publication is subject to change without notice and may contain technical inaccuracies or
graphical discrepancies. Changes or improvements made to this product will be updated in the next
publication release. No part of this document may be reproduced or transmitted in any form or by any
means, electronic or mechanical, for any purpose, without the express written permission of MagTek, Inc.
MagTek® is a registered trademark of MagTek, Inc.
ExpressCard 2000 is a trademark of MagTek, Inc.
MagnePrint® is a registered trademark of MagTek, Inc.
Microsoft® and Windows® are registered trademarks of Microsoft Corporation.
All other system names and product names are the property of their respective owners.
Table 0.1 - Revisions
<IntelliCAT>| <Installation User Support Document>
<IntelliCAT>| <Installation User Support Document>
Windows 7 Recommended Power Options Settings
Go to Control Panel – type Power Options then edit the settings as noted below. Failure to set the
power options may cause the USB devices to fail to respond. Note: If the Power Options settings
are managed through a Global script, please adjust the script to support the settings noted below
Example of changing a Balanced Power Option setup
Recommended Power Option setting is Maximum Performance
Set the Hard disk – Turn off hard disk after setting , set to NEVER
Wireless Adapter Settings, Power Saving mode, set to Maximum Performance
<IntelliCAT>| <Installation User Support Document>
Sleep After setting, set to NEVER
Allow hybrid sleep set to OFF
Hibernate after, set to NEVER
Allow wake timers, set to DISABE
<IntelliCAT>| <Installation User Support Document>
USB settings
USB selective suspend settings, set to DISABLED
PCI Express, Link State Power Management, set to OFF
Loading...