Magnum Venus Plastech System One FRP Start-Up User Manual

FRP

System

One

Pumping System

Quick List Instructions

Start-Up Sheet

1. Check & fill solvent system

2. Check & fill resin &
catalyst supply

3. Place suction wand in
resin supply

4. Prime resin pump

5. Prime catalyst pump and
set catalyst percentage

Daily Settings:

Solvent Pressure ________________
Gun Pressure________________
Pump Pressure ________________
Nozzle P/N ________________

6. Check system for fluid leaks

7. Set air pressure to
gun/chopper

8. Install turbulent mixer in
mix chamber

9. Select spray tip, flow nozzle
or convergence tip

10. Check chopper motor ,
rubber roller adjustment

1 1. Attach chopper cover & chute

12. Adjust fan pattern

13. Adjust chop pattern

Catalyst % ________________

14. See installation sheet and
manual for further instructions

Part No. M1 100-1-2

FRP SystemOne

Pumping System

Installation & Setup

Quick List Instructions

1. Unpack unit & components

2. Place unit & stand pipe in
base plate or portable cart (or
mount to wall with wall brackets)
Tighten bolts to secure

3. Install catalyst jug

4. Install resin surge chamber &
filter assembly

5. Install manifold air hose to
power cylinder

6. Attach hose fittings to resin
pump, catalyst pump, air &
flush tank

7. Install boom to mast
(if applicable)

8. Hang hose on boom
(if applicable)

9. Attach pickup hose

10. Place flush tank in holder and
attach air hose from manifold

1 1 . Double check all hose fittings

12. See start-up sheet and manual
for further instructions

Part No. M1 100-1-2