Magnum Dynalab MD-107T User Manual

Magnum Dynalab MD 107T/107TR

ANALOG FM TUNER

INSTRUCTION MANUAL

- 2 -

TABLE OF CONTENTS

A MESSAGE FROM THE PRESIDENT 3

UNPACKING YOUR 107T 4

SETTING UP YOUR MD 107T 5

CONTROLS AND FUNCTIONALITY 6

DISPLAYS AND METERS 7

CHECKING OUT YOUR MD 107T 8

TUNER REMOTE (OPTIONAL) 9

RC6 REMOTE IMAGE 10

TROUBLESHOOTING 11

RECEPTION TECHNIQUES 12

Antenna Cabling: 12

Types of Antennas: 12

FM RECEPTION AIDS AND ACCESSORIES 13

PRODUCT SPECIFICATIONS 14

SAFETY SHEET 15

LIMITED WARRANTY 16

- 3 -

A Message From the President

Thank you for choosing the Magnum Dynalab “
has been given in the design, manufacturing and selection of components for the
“

MD 107T”

experience will be optimized for years.

The front end of all Magnum Dynalab tuners is an exclusive “in house” designed
and manufactured component, we are the only company in the world that does
their own R.F. “Front-end”. The reason that we design and build our own front-end
is that no other manufacturer can make one that meets our exacting
specifications. The importance of a front-end to the tuner is the equivalent of a
high performance laser mechanism to a CD transport. The front-end must gather
the FM signal and isolate it from the extraneous aberrations inherent in the
environment as well as the FM stations adjacent to it. Our rigid criteria for our
tuners and their front-ends insure that you get the most out of your FM reception
with the highest degree of consistency available in the industry.

To insure that all specifications on our tuners are met at ALL frequencies, we
manually align our tuners front-end at three frequencies (92 MHz, 101.5 MHz
and 106MHz). This process optimizes tuning performance across the entire FM
band, so that you attain the same levels of quality regardless of where you are
tuned.

These procedures also ensure that the balance between SENSITIVITY,
SELECTIVITY and MUSICALITY are maintained. Your tuner is now optimized to
reject strong adjacent channel noise, provide more consistent levels of tuning
performance across FM band and to have a superior ability to isolate the station
you wish to listen to from the extraneous interference of the FM signals.

Once again MAGNUM DYNALAB thanks you for including our product in your
audio system, we are sure that you will have years of listening pleasure from your

MD 107T

“
listening to FM, please feel free to contact us on our toll free number, 1-800­551-4130 or via email at: [e-mail].

Respectfully yours,
Larry Zurowski

President

FM Tuner. This complete process will insure that your listening

”. If there is anything else we can offer to aid your enjoyment in

MD 107T

” FM Tuner. Great care

- 4 -

UNPACKING YOUR 107T

Carefully inspect all sides of the shipping carton for damage. If there are marks or
holes in the carton make note of the location in relation to the unit inside. Any
obvious dents or scuff marks should alert you to the possibility of damage.
Carefully remove the MD 107T from the end caps and wrapping, inspect all
sides. Pay special attention to the corresponding areas on the unit where damage
was found to the shipping carton. If damage is evident, document the type and
extent of the damage, then repack the unit and call the dealer.

KINDLY DO NOT SEND THE UNIT BACK TO THE SHIPPER UNTIL YOU HAVE BEEN
ASKED TO DO SO.

DO NOT DISCARD THE PACKING MATERIALS AND CARTONS. Should there be a
necessity to return the unit for any reason, it must arrive safely and suitably
packaged in order for our receiver to accept it from the carrier. Also, if the unit
has incurred damage as a result of improper packaging, it is not likely that a
claim for the damage against the carrier will be successful.

Likewise, we will ship your unit back to you only in factory-approved packaging,
however, if the unit were to arrive at the factory in anything other than factory
approved packaging, we reserve the right to return the product in factory­approved packaging and charge the cost of the packaging to the shipper. This is
the only way we can assure your unit of a safe return (damage by carrier
excepted).

- 5 -

SETTING UP YOUR MD 107T

1. Place your tuner the shortest distance possible from your pre-amplifier/

integrated amplifier, being careful to avoid areas that may cause extreme
temperatures.

2. Connect your tuner to the pre-amplifier, using cables/ inter-connects that are

consistent with the rest of the inter-connects in your system. For a single ended
(un-balanced) system the cables will be connected to the RCA connectors labeled
“output to preamp” on the rear panel of your tuner to an unused aux. input on the
rear of your pre-amplifier/ integrated amplifier. For connection to a balanced
system, the balanced cables will be connected from the XLR outputs marked
“output balanced” on the rear of your tuner to the balanced inputs on the rear of
your pre-amplifier/ integrated amplifier.

3. Connect your FM antenna cable to the ANTENNA IN terminal on the rear

panel of your tuner. The connection type on the back of your tuner is an “F”
connector (75 ohms). Should your antenna cable be 300 twin lead, you may
convert this to 75 ohms with a 300 ohm to 75 ohm balun/ transformer.

4. Make sure that the center conductor of the cable is properly inserted into the

connector. If you do not possess an antenna, attach the temporary wire
(enclosed in box) to your tuner. Place this into the “F” connector input on the rear
of your tuner.

5. If you have the D.A.C. option, connect the digital inter-connect to either the

“D1”, “D2”, OR “D3” input.

6. Unwrap the EIA AC cord and plug the EIA end into the rear socket marked

“Power Input” on the rear panel of your tuner. Plug the other end of the AC cord
into a 120/220/230/240 volt continuous AC source that you are using.

Please note that the piece of wire provided as an antenna should only be used as
a medium to test and setup the tuner. A better antenna system is
recommended. Magnum Dynalab offers a number of different antennae, these
antennae are discussed in the

Note: Many countries that use 220/230/240 volts have a special FM
transmitter; tuning de-emphasis for these countries may be different. Please
consult Magnum Dynalab for the correct usage. If your tuner is used in a country
where the tuning de-emphasis is set incorrectly the sonic performance will be
seriously affected.

Reception Techniques

in the back of the manual.