Magneti Marelli S p A EN1 User Manual

To Whom It May Concern:

FCC ID: RX2EN1
IC: 4983A-EN1

The Bluetooth/WLAN Module “EN1” is for OEM installation only.
When integrating the Module into the end product, the final user manual of the end
product will include the following statements for FCC approval:

The end product has to be labeled as follows:
CONTAINS FCC ID: RX2EN1

FCC § 15.19 Labelling requirements

This device complies with part 15 of the FCC Rules and Industry Canada license-exempt
RSS standard(s). Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,

including interference that may cause undesired operation.

FCC § 15.21 Information to user

Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.

RF Exposure Requirements

To comply with FCC RF exposure compliance requirements, the device must be installed to
provide a separation distance of at least 20 cm from all persons.

The Bluetooth/ WLAN Module “EN1” is for OEM installation only.
When integrating the Module in the in the end product, the end product and the final
user manual of the end product will include the following statements for Industry
Canada approval:

The end product has to be labeled as follows:
CONTAINS IC: 4983A-EN1

INDUSTRY CANADA Statements

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1)
l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.

RF Exposure Requirements

This equipment complies with Canada radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator and your body.

Déclaration d’exposition aux radiations:
Cet équipement est conforme aux limites d’exposition aux rayonnements IC établies pour un
environnement non contrôlé. Cet équipement doit être installé et utilisé avec un minimum de
20 cm de distance entre la source de rayonnement et votre corps.

i.V.

Signature

Carsten Steinröder on behalf of Magneti Marelli S.p.A.
7Layers AG Viale C. Emanuele II, 150
Borsigstr.11 10078 Venaria
40880 Ratingen ITALY
Germany