Magnavox MSH315V Owner's Manual

MODEL: MSH315V

PLEASE READ BEFORE OPERATING THIS EQUIPMENT.

OWNER'S MANUAL

AMAZON ALEXA
VOICE ACTIVATED
WIFI SPEAKER

with Bluetooth® Wireless Technology

Size: 148.5(W) x 210(H)mm (A5)

CAUTION:
THIS DIGITAL VIDEO DISC PLAYER EMPLOYS A
LASER SYSTEM.
TO ENSURE PROPER USE OF THIS PRODUCT.
PLEASE READ THIS OWNER`S MANUAL CAREFULLY
AND RETAIN FOR FUTURE REFERENCE. SHOULD
THE UNIT REQUIRE MAINTENANCE, CONT ACT AN
AUTHORIZED SERVICE LOCATION-SEE SERVICE
PROCEDURE.
USE CONTROLS, ADJUSTMENTS OR THE
PERFORMANCE OF PROCEDURES OTHER THAN
THOSE SPECIFIED HEREIN MAY RESULT IN
HAZARDOUS RADIATION EXPOSURE.
TO PREVENT DIRECT EXPOSURE TO LASER BEAM,
DO NOT TRY TO OPEN THE ENCLOSURE. VISIBLE
LASER RADIATION MAY BE PRESENT WHEN THE
ENCLOSURE IS OPENED. DO NOT STARE INTO BEAM.

WARNING:

TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, AND ANNOYING INTERFERENCE, USE THE
RECOMMENDED ACCESSORIES ONLY.

The lightning flash with arrowhead symbol
within an equilateral triangle is intended to alert
the user to the presence of uninsulated
dangerous voltage within the product`s
enclosure that may be of sufficient magnitude to
constitute a risk of electric shock to persons.

The exclamation point within an equilateral
triangle is intended to alert the user to the
presence of important operating and

literature accompanying the appliance.

FCC NOTICE:
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV
technician for help.

FCC WARNING:
To assure continued compliance, follow the attached
installation instructions and use only shielded cables
when connecting to other devices. Modifications not
authorized by the manufacturer may void user`s authority
to operate this device.

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK). NO USER-SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.

maintenance (servicing) instructions in the

IMPORTANT SAFETY INSTRUCTIONS

2

Before using the unit, be sure to read all operating instructions carefully. Please note that these
are general precautions and may not pertain to your unit.

1) Read these instructions.
All the safety and operating instructions should be read before the product is operated.

2) Keep these instructions.
The safety

and operating instructions should be retained for future reference.

3) Heed all warnings.
All warnings on the product and in the operating instructions should be adhered to.

4) Follow all instructions.
All operating and use instructions should be followed.

5) Do not use this apparatus near water.
Do not

use this product near water and moisture, for example: near a bathtub, washbowl, kitchen

sink or laundry tub; in a wet basement; or near a swimming pool.

6) Clean only with dry cloth.
Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol
cleaners

. Use a dry cloth for cleaning.

7) Do not block any ventilation openings. Install in accordance with the manufacturer's
instructions.
Slots and openings in the cabinet and in the back or bottom are provided for ventilation, to ensure
reliable operation of the product and to protect it from overheating

. These openings must not be
blocked or covered. The openings should never be blocked by placing the product on a bed, sofa,
rug or other similar surface. This product should never be placed near or over a radiator or heat
source. This product should not be placed in a built

-in installation such as a bookcase or rack

unless proper ventilation is provided or the manufacturer's instructions have been adhered to.

8) Do not install near any heat sources such as radiators, heat registers, stoves, or other
apparatus(including amplifiers) that produce heat.

9) Do not defeat the safety

purpose of the polarized or grounding-type plug. A polarized plug

has two blades with one wider than the other. A grounding type plug has two blades and a
third grounding prong. The wide blade or the third prong are provided for your safety. If the

provided plug does not fit

into your outlet, consult an electrician for replacement of the

obsolete outlet .

10) Protect the power cord from being walked on or pinched particularly at plugs, convenience
receptacles, and the point where they exit from the apparatus.

11) Only use attachments/accessories specified by the manufacturer.

12) Use only with

the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold

with the apparatus. When a cart is used, use caution when moving the cart/apparatus
combination to avoid injury from tip-over.
An appliance and cart combination should be moved with care.
Quick stop, excessive force and

uneven surfaces may cause the

appliance and cart combination to overturn.

13) Unplug this apparatus during lightning storms or when unused for long periods of time.
To protect your product from a lightning storm, or when it is left unattended and unused for long
periods of time, unplug it from

the wall outlet and disconnect the antenna or cable system. This

will prevent damage to the product due to lightning and power-line surges.

14) Refer all servicing to qualified service personnel. Servicing is required when the apparatus
has been damaged in any way, such as power-supply cord or

plug is damaged, liquid has
been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain
or moisture does not operate normally, or has been dropped.

15) Power source
This product should be operated only from the type of power source indicated on the marking label

.

If you are not sure of the type of power supply to your home, consult your appliance dealer or local
power company. For products intended to operate from battery power, or other source, refer to the
operation instructions.

16) Power lines

An outside antenna system should not be located

in the vicinity of overhead power lines or other
electric light or power circuits, or where it can fall into such power lines or circuits. When
installing an outside antenna system, extreme care should be taken to keep from touching such
power lines or circuits as contact with them might be

fatal.

For example, this unit may not have the capability to be connected to an outdoor antenna.

Portable Cart Warning

IMPORTANT SAFETY INSTRUCTIONS

3

17) Overloading

Do not overload wall outlets and extension cords as this can result in a risk of fire or electric

shock.

18) Object and liquid entry

Never push objects of any kind into the product through openings as they may touch dangerous
voltage points or short out parts that could result in fire or electric shock. Never spill or spray any
type of liquid on the product.

19) Outdoor antenna grounding

If an outside antenna is connected to the product, be sure the antenna system is grounded so as to
Provide some protection against voltage surges and built up static charges. Section 810 of the
National Electric Code ANSI/NFPA 70 provides information with respect to proper to grounding
of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge product,
size of grounding conductors, location of antenna-discharge product, connection to grounding
electrodes and requirements for the grounding electrodes.

Do not attempt to service this product yourself as opening or removing covers may expose you to
dangerous voltage or other hazards. Refer all servicing to qualified service personnel.

When replacement parts are required, be sure the service technician uses

replacement parts

specified by the manufacturer or those that have the same characteristics as the original parts.
Unauthorized substitutions may result in fire or electric shock or other hazards.

Upon completion of any service or repairs to this product, ask the service technician to perform
safety checks to determine that the product is in proper operational condition.

The product should be mounted to a wall or ceiling only as recommended by the manufacturer.

Unplug this product from the wall outlet and refer service to qualified service personnel under the
following conditions.
a) When the power-supply cord or plug is damaged.
b) If liquid has been spilled or objects have fallen into the product.
c) If the product has been exposed to rain or water.
d) If the product does not operate normally by following the operating instructions. Adjust only

those controls that are covered by the operating instructions, as an adjustment of other
controls may result in damage and will and require extensive work by a qualified technician
to restore in the product to its normal operation.

e) If the product has been dropped

or the cabinet has been damaged.

f ) When the product exhibits a distinct change in performance-this indicates a need for service.

This reminder is provided to call the CATV system installer

's attention to Article 820-40 of the
NEC that provides guidelines for proper grounding and, in particular, specifies that the cable
ground shall be connected to the grounding system of the building, as close to the point of cable
entry as practical.

NOTE: Refer all servicing to qualified service personnel. Servicing is required when
the unit has been damaged in any way such as the following: the power-supply cord
or plug has been damaged, liquid has been spilled into unit, the unit has been
exposed to rain or moisture, the unit has been dropped or the unit does not operate normally.

25) Note to CATV system installer

24) Damage requiring service

23) Wall or ceiling mounting

22) Safety check

21) Replacement parts

20) Service

IMPORTANT SAFETY INSTRUCTIONS

4

Top View

Rear View

1

2
3

4

5
6

7

8

9

1. Decorative Ring with LED Lights

4. VOL (Volume) - Button

2. /MODE Button

3. VOL (Volume) + Button

7. Indicator

8. Built-in Microphone

9. Charge Indicator

11. AUX IN Jack

6. (Microphone On) Button

8

Main Unit:

MODE

WPS

VOL+

VOL-

10. DC 5V (In) Jack
(Micro USB Port)

5. /WPS (Microphone Off/Wi-Fi
Protected Setup) Button

LOCATION OF CONTROLS

5

through the microphone on

Charging Station:

Top View

Rear View

12

13

12. Charging Contacts

13. DC 5V (In) Jack (Micro USB Port)

LOCATION OF CONTROLS

12

Bottom View

6

through the microphone on

7

To wall outlet

AC/USB Adaptor

POWER SOURCE

1. Connect the Micro USB Plug from the supplied AC/USB Adaptor to the DC 5V (In)
Jack (Micro USB Port) on the Charging Station.

2. Plug the AC/USB Adaptor to the AC wall outlet having AC 100-240V~, 50/60Hz.

1.Open the rubber cover on the rear of unit as illustrated below:

4. While charging, the Red Charging Indicator on the top of unit will illuminate.
When finished charging, it will turn off.

2. Connect the Micro USB Plug from the supplied AC/USB Adaptor to the DC 5V

(In) Jack (Micro USB Port).

3. Plug the AC/USB Adaptor to the AC wall outlet having AC 100-240V~, 50/60Hz

as illustrated below:

The unit has a built-in Li-ion rechargeable battery, charge it before use or when it is

drained as below:

Charging Through the Unit Directly:

Charging Through the :Charging Station

To DC 5V (In) Jack on the rear of unit

Notes:

8

To wall outlet

AC/USB Adaptor

2. While charging, you can operate the unit as usual.

D. Battery life naturally shortens slowly over time.
E. The rechargeable battery incorporated in this product is not user replaceable.

1. Clean the Charging Contacts on the bottom of unit and top of Charging Station
prior to charging unit.

4. Your battery will last longer if you follow these simple guidelines for caring
and storing:

A. Before first time use, charge it approximately 4 hours until the unit is fully

charged.

B. Recharge and store the unit within the temperature range of 5°C~35°C

(40°F~95°F).

C. Do not charge longer than 24 hours. Excessive charging or running the unit

until the battery fully drains will damage battery. Battery life will be extended

if you keep the battery fully charged.

3. Place the unit to the Charging Station as illustrated below:

4. While charging, the Red Charging Indicator on the top of unit will illuminate.
When finished charging, it will turn off.

To DC 5V (In)
jack on the
charging station

3. If left unused for a long period of time, unplug the Adapter from wall outlet.

9

OPERATION

First time use or re-pairing the unit to a new BT Device, pair as below:

5. If pairing is complete you may now play music with your external BT Device.

6. During playback:

Using the controls on the paired BT Device to pause, skip tracks as usual.

Press the VOL + or – Buttons on the top of unit to adjust the volume level as

desired.

7. To shut off the unit, press and hold the /MODE Button approximately 1
second then release the button.

1. Power on the unit by pressing and holding the /MODE Button on the top of unit

approximately 2 seconds until the Blue and Green Indicators on the top of unit is

illuminate and blink.

2. Wait approximately 25 seconds until the Blue Indicator is not on. (Only the Green
Indicator will illuminate and blink).

4. Power on the external BT Device and enter to BT searching mode. Start pairing
following the on screen instructions from the external BT Device. When paired,

the Blue Indicator will stop blinking.

If while pairing you are asked for a code please try "0000" or "1234".

"MSH315V" will appear on the display of external BT Device.

BT MODE
BT (Bluetooth pairing) and play:

3. Press the /MODE Button repeatedly until Blue Indicator begins to blink, this

will access BT Mode.

Note: If the unit is already added into the Wi-Fi network. Then:

Power on the unit and wait approximately 25 seconds as previously

instructed. The unit will automatically connect to the Wi-Fi network.

will illuminate and stop blinking.

The Blue Indicator will turn off and the Green Indicator/Decorative Ring

Press the /MODE Button repeatedly until the Blue Indicator begins to

blink, this will access BT Mode.

When the external BT Device searches for the unit, our model number

Notes: