Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
Consult the dealer or an experienced radio/TV technician for help.
(1) This device may not cause harmful interference, a nd
(2) This device must accept any interference received, including interference
FCC NOTICE:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference wi
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
which the receiver is connected.
FCC STATEMENT:
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
ll not occur in a particular
that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with minimum distance 20cm between the radiator & your body.
FCC WARNING:
To assure continued operation, follow the attached installation instructions and
use only shield cables when connecting to other devices. Changes or
modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
2
Page 3
FRONT VIEW:
TOP VIEW:
LOCATION OF CONTROLS
1
2
3
4
5
6
--------------------------
1. (Skip Backward) Button
2. (Skip Forward) Button
3.BASS Volume Control Knob
4.SOURCE Button
5. (Play/Pause/Mute) Button
6.Volume Control Knob
7.Power (Decorative Lights) ON/OFF Switch
8.
9.DC IN Port (Micro USB Port, for charging only)
10.INDICATORS
11.AUX IN Jack
Red Charging Indicator
3
10
7
8
11
9
Page 4
POWER SOURCE:
The unit has a built in Li-ion rechargeable battery, recharge it before use or
when it is drained as follows:
1.Connect the Micro USB Plug
the Micro USB Port on thetop of unit.
2.Connect the full sized USB
to the USB Port on the Personal Computer or USB Charger.
(Personal Computer and USB Charger NOT supplied).
3.When charging, the Red Charging Indictator on the top of unit will
illuminate. When finished, it will turn off.
from the supplied USB Connection Cable to
Plug from the supplied USB Connection Cable
To DC IN Port (Micro USB Port)
on the top of unit
USB Connection Cable
To USB Port on PC or USB Charger
NOTES:
Your battery will last longer if you're following these simple guidelines for
caring and storing:
A. Before first time use, charge it approximately 4 hours until the unit is fully
charged.
B. Recharge and store the unit within the temperature range of 5°C~35°C
(40°F~95°F).
C. Do
D. Battery life naturally shortens slowly over time.
E. The rechargeable battery incorporated in this product is not user
not charge longer than 24 hours. Excessive charging or running the
unit until battery fully drains will damage battery. Battery life will be
extended if you keep the battery fully charged.
replaceable.
Main Unit
PC
4
Page 5
OPERATION:
BT Mode:
BT (Bluetooth) pairing:
First time use or re-pairing the unit to a new BT Device, pair as follows:
1. Slide the Power (Decorative Lights) ON/OFF Switch to “ON + LIGHTS”
position to power on the unit and the Decorative Lights.
2. Or, slide the Power (Decorative Lights) ON/OFF Switch to “ON” position
to power on the unit only.)
3. The Blue Indicator on the top of unit will illuminate and blink.
4. Power on the external BT Device and enter to BT searching mode.
Start pairing following the on screen instructions from the external BT
Device. When paired, the Blue Indicator will stop blinking.
5. If pairing is complete you may now play music with your external BT Device.
6. During playback
Turn the Volume Control Knob to adjust volume level as desired.
Turn the BASS volume Control Knob to adjust bass level
(low audio frequency) as desired.
Press the Button on the unit to pause, press again to resume normal
playback.
Press and release the or Buttons repeatedly to skip tracks.
Slide the Power (Decorative Lights) ON/OFF Switch to “ON” position to
turn off the Decorative Lights.
Slide the Power (Decorative Lights) ON/OFF Switch to “ON + LIGHTS”
position to turn on the Decorative Lights.
If external audio device was connected to the unit through AUX IN
(LINE IN) Jack, press the SOURCE Button on the top of unit to enter
to AUX IN mode. The color of the Blue Indicator will turn to Green.
Press again to turn back to BT mode, the color of the Green Indicator will
turn to Blue.
7. When finished listening, slide the Power (Decorative Lights) ON/OFF Switch
to “OFF” position to shut off the unit.
Notes:
When the external BT Device searched the unit, our model number
“MMA3680” will appear on the display of external BT Device.
If while pairing you are asked for a code please try "0000" or "1234".
5
Page 6
Normal operation after pairing:
1. Power on the external BT Device and enter to BT playback mode.
2. Power on the unit as previously instructed. The Blue Indicator on the top of
unit will illuminate and blink.
3. Wait a few seconds until the unit is automatically paired to the external BT Device.
The Blue Indicator will stop blinking.
4. After pairing is complete you may now play music with your external BT Device.
AUX IN (LINE IN):
To listen from an external Audio Player such as MP3 Player, Discman…etc.
1. In power off mode, connect one end of the supplied Audio Connection Cable to
the AUX Out / Line Out / Phone Jack on the external Audio Player.
2. Connect the other end of the cable to the AUX IN Jack on the top of unit as
illustrated below:
EXTERNAL DEVICE
+
--------------------------
TO AUX OUT/LINE OUT/
PHONE JACK ON THE
EXTERNAL AUDIO PLAYER
3. Slide the Power (Decorative Lights) ON/OFF Switch to “ON + LIGHTS”
position to power on the unit and the Decorative Lights.
4 Or, slide the Power (Decorative Lights) ON/OFF Switch to “ON” position to
power on the unit only.
5. The Blue Indicator on the top of unit will illuminate.
6. Press the SOURCE Button on the top of unit to enter to AUX IN mode,
the color of the Blue Indicator will turn to Green.
7. Play the music on the connected Player as usual. (Make sure the volume level of
the connected Audio Player is turned to high level.)
8. During playback:
Turn the Volume Control Knob to adjust volume level as desired.
Turn the BASS Volume Control Knob to adjust bass level (low audio frequency)
as desired.
Press the Button on the unit to mute the sound, press again to turn the sound
back.
Slide the Power (Decorative Lights) ON/OFF Switch to “ON” position to turn off
the Decorative Lights.
Slide the Power (Decorative Lights) ON/OFF Switch to “ON + LIGHTS” position
to turn on the Decorative Lights.
If external BT device was paired to the unit, press the SOURCE Button on the top
of unit to enter to BT mode. The color of the Green Indicator will turn to Blue.
Press again to turn back to AUX IN mode; the color of the Blue Indicator
will turn to Green.
9. When finished listening, slide the Power (Decorative Lights) ON/OFF Switch
to “OFF” position to shut off the unit.
6
Page 7
B
T
V
position
V
i
V
d
T
t
T
unit
TROUBLE SHOOTING GUDIE
Check the following before requesting service:
SYMPTOM
Can’t power on
uilt-in battery drained
POSSIBLE CAUSE
he unit in power off mode
No sound or sound
weak
Sound distortion
olume of the unit was set to minimum
olume level of paired/connected device
s in low level
Volume level too high
olume level of the paired/connected
evice too high
POSSIBLE SOLUTION
Recharge the battery as page 4
Slide the Power (Decorative Lights)
ON/OFF Switch to
“ON
” position to power on the unit.
or
The Blue Indicator on the top of unit
will illuminate
Increase the volume level by turn the
Volume Control Knob clockwise
Rise the volume level of the
paired/connected device
Reduce the volume level by turn the
Volume Control Knob counterclockwise
Reduce the volume level of the
paired/connected device
“
ON + LIGHTS”
BT not functioning
he external BT device had NOT paired
o the unit
he external BT device too far from the
7
Pair the external BT device to the unit
as page 5
Place the external BT device close to the
unit
Page 8
SPECIFICATIONS:
Power source:Built-in DC 3.7 V, 1200 mAh (4.44 WH) rechargeable Li-ion
Battery Recharge by DC 5 V through DC IN Port (Micro
USB Port) on the top of unit
Impedance of the speakers:
Audio power:
BT Version:
BT Operation Distance:
2 x 5 W ; 2 ohm
3 W per Channel (Total 6 W, RMS)
4.2
≧ 32 Feetinopenarea
PACKAGE INCLUDES
1 x Owner's Manual
1 x USB Connection Cable (For charging only)
1 x Audio Connection Cables with 3.5mm Plugs
SPECIFICATIONS AND ACCESSORIES ARE SUBJECT TO CHANGE
WITHOUT NOTICE
8
Page 9
LIMITED WARRANTY
Craig Electronics warrants this product to be free from manufacturing defects in material
and workmanship under normal use for a period of 180 days from date of purchase. If
service is required, please return the product to the store where it was purchased for
exchange; or, pack the unit in the original packing material with all accessories if
applicable, a copy of your sales receipt and a Cashier’s check or Money Order for $7 (to
cover shipping and handling costs) payable to Craig Electronics Inc. For consumers in
Canada, please make sure that the cashier check or money order is redeemable through
a U.S. bank. Ship your product freight pre-paid. Your unit will be repaired, replaced or if
the unit cannot be repaired or replaced, a refund will be forwarded to you within four
weeks of receipt of your unit. Please ship your unit to:
Craig Electronics Inc.
1160 NW 163 Drive
Miami, Fl 33169
This warranty is void if the product has been: a) Used in a commercial application or
rental. b) Damaged through misuse, negligence, or abuse. c) Modified or repaired by
anyone other than an authorized Craig service center. d) Damaged because it is
improperly connected to any other equipment.
Note: This warranty does not cover: a) Ordinary adjustments as outlined in the Owner’s
Manual which can be performed by the customer. b) Damage to equipment not properly
connected to the product. c) Any cost incurred in shipping the product for repair. d)
Damage to the product not used in the USA.
This warranty is not transferable and only applies to the original purchase. Any implied
warranties, including the warranty of merchantability, are limited in duration to the period
of this expressed warranty and no warranty whether expressed or implied shall apply to
the product thereafter.
Under no circumstance shall Craig be liable for any loss or consequential damage arising
out of the use of this product. This warranty gives specific legal rights. However, you may
have other rights which may vary from state to state. Some states do not allow limitations
on implied warranties or exclusion of consequential damage. Therefore, these
restrictions may not apply to you.
This product has been manufactured by and is sold under the responsibility of Craig
Electronics Inc, and Craig Electronics Inc is the warrantor in relation to this product.
MAGNAVOX and SMART. VERY SMART are registered trademarks of Koninklijke Philips
N.V. and are used under license from Koninklijke Philips N.V.
To Obtain Service on your Product
email:service@craigelectronics.com
Printed in China MMA3680_WC_E0GZ1_B0US
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.