Magnavox 9MDPF20 Quick Start Guide
There are many ways to connect your new TV/DVD to your other equipment.This Quick-Use
Guide shows the easiest, most common connections for the TV/DVD.
1
Disconnect all equipment from the power outlets. Connect the equipment to the power outlets
only after you have finished hooking up everything. Never make or change connections with equipment
connected to the power outlet.
2
If you do not have a Cable Box, simply connect your Antenna or Cable TV signal directly to the
ANT(enna) jack on the rear of the TV/DVD.
3
If you do have a Cable Box or Satellite Receiver, first connect the Cable TV or Satellite signal to
the IN jack on the Cable Box or Satellite Receiver. Then, use an RF coaxial cable (not supplied)
to connect the OUT jack of the Cable Box or Satellite Receiver to the ANT(enna) jack on the
TV/DVD.To view any channel, set the TV/DVD to the output channel of the Cable Box or Satellite Receiver
(channel 3 or 4).Then, select channels at the Cable Box or Satellite Receiver.
4
When all connections are complete, plug the power cord of the TV/DVD into an active power
outlet.
5
Press the STANDBY-ON 2 button on the TV/DVD or its remote to turn on the TV/DVD.
The first time you turn on the TV/DVD, you should complete the TV/DVD setup. See the
other side of this Quick-Use Guide for details.
Quick-Use Guide
Quick-Use Guide
9MDPF qug 20/03/2003 10:24 AM Page 1
ANTENNA or
CABLE TV SIGNAL
2
CABLE TV SIGNAL
CABLE BOX
IN
OUT
DC 13.2V
4
ANT.
L
AUDIO OUT
R
COAXIAL
ANT.
OR
3
RF COAXIAL
CABLE
ANT.
Playing a Disc
1
Press STANDBY-ON 2 to turn on the TV/DVD.
2
Press EJECT / to open the disc tray. Put a Disc
in the tray with the label facing up and the shiny side
facing down.
3
Press PLAY B to close the tray. Playback may
start automatically. If not, press PLAY B again.
If a DVD Disc menu appears, use the 1 234, ENTER, or
Number buttons to select features or start playback.
Follow the instructions in the menu.
4
To stop playing the Disc, press STOP 9.
9MDPF20 / 8239 300 27161
Setting Up the TV/DVD the First Time
1
Press STANDBY-ON 2 to turn on the TV/DVD.
2
Press ENTER repeatedly to select English, French,
or Spanish as the language for TV/DVD setup menus.
3
Press 3 or 4 to select AUTO PRESET.Then press
ENTER to set up TV channels. When setup is
complete, the lowest TV channel will appear on the
TV/DVD.
4
To watch TV,press the CH. 3 or 4 buttons to
select memorized channels. Remember,if you are using a
Cable Box or Satellite Receiver, set the TV/DVD to
channel 3 or 4. Change channels at the Cable Box or
Satellite Receiver.
- SET UP-
2 LANGUAGE
[ENGLISH] ESP FRA
AUTOPRESET
Playable Discs
The TV/DVD will play the following Discs.
DVDs must have a Region Code of ALL regions or Region 1.
DVDs must be recorded in the NTSC Color System.
Quick-Use Guide (cont’
Quick-Use Guide (cont’
d)
d)
1
2
3
4
9MDPF qug 20/03/2003 10:24 AM Page 2
1
4
2-3
ALL
1
ReWritable
Recordable
Loading...