Magnavox 13MC3206 User Manual

CABLE BOX

CABLE TV SIGNAL

RF COAXIAL CABLE

ANTENNA or CABLE TV SIGNAL

OUT

ANT.ANT.

Disconnect all equipment from the power outlets. Connect the equipment to the power outlets only after you have finished hooking up everything. Never make or change connections with equipment connected to the power outlet.

If you do not have a Cable Box, simply connect your Antenna or Cable TV signal directly to the ANT(enna) jack on the rear of the TV/DVD.

If you do have a Cable Box or Satellite Receiver, first connect the Cable TV or Satellite signal to the IN jack on the Cable Box or Satellite Receiver. Then, use an RF coaxial cable (not supplied) to connect the OUT jack of the Cable Box or Satellite Receiver to the ANT(enna) jack on the TV/DVD. To view any channel, set the

TV/DVD to the output channel of the Cable Box or Satellite Receiver (channel 3 or 4).Then, select channels at the Cable Box or Satellite Receiver.

When all connections are complete, plug the power cord of the TV/DVD into an active power outlet.

Press STANDBY-ONy on the TV/DVD or its remote to turn on the unit.

13MC3206

There are many ways to connect your new TV/DVD to your other equipment.This Quick Start Guide shows the easiest, most common connections for the TV/DVD.

T8201UB_QSG_EN 3/7/06 12:03 PM Page 1

Quick Start Guide (cont’d)

Detailed playback features and additional functions are described in the

accompanying owner’s manual.

Watching TV

Press STANDBY-ONy to turn on the TV/DVD.

This unit memorizes TV channels when you connect an Antenna or Cable TV signal as described in this Quick Start Guide. To watch TV, use CH. ▲/▼ to select memorized channels. If a channel is skipped, use the Number buttons to select it.To update your channels later, refer to the owner’s manual.

Press VOL.X/Yto adjust the volume.

Playable Discs

The TV/DVD will play the following discs.

is a trademark of DVD Format/Logo Licensing Corporation.

Windows Media is a trademark of Microsoft Corporation. DVDs must have a Region Code of ALL regions or Region 1.

DVDs must be recorded in the NTSC Color System.

2 3

Printed in Malaysia

8239 300 47381

1EMN21732

T8201UB*****

Playing a DVD

With the unit on, press OPEN/CLOSE A

to open the disc tray. The unit will switch to DVD mode automatically.

Place a disc on the tray, with the label facing up and the shiny side facing down.

Press PLAY B. The tray will close and playback will begin. If playback does not start automatically, press PLAY B again. If a DVD Menu appears instead, use

KLsB, ENTER or

the Number buttons to choose features or start play from the menu.

Press STOP C to stop playback.

STANDBY-ON

LABEL

T8201UB_QSG_EN 3/7/06 12:03 PM Page 2

VOLUME 20

STANDBY-ON

OPEN/CLOSE

123

456

ENTER

DISC SET-UP

PICTURE

CH. VOL.

/SLEEP

SELECT

DISPLAY

MUTE

MODE

ALL

STANDBY-ON

OPEN/CLOSE

123

456

PREV NEXT

PLAY

SLOW PAUSE

ENTER

+100

+10

TITLE

CLEAR

STOP

RETURN

DISC SET-UP