MAGNADYNE PLUS-4700 User's Manual
R
Vehicle Security
OWNER’S
MANUAL
Model: PLUS-4700
For Technical Assistance, please call (800) 638-3600,
or visit www.magnadyne.com
Congratulations on your purchase of a quality Carbine automotive security system. Carbine automotive
security products have been designed to provide the consumer with a product that is technologically
superior and will provide years of trouble free operation.
The information enclosed will provide a ready reference of the operation and maintenance of your new
security system.
Remote Control Transmitters
Regular Transmitter
Lock
Unlock
Panic
Aux
Lock
Panic
Passive Transmitter
(Optional)
Unlock
Aux
Passive
Unlocking
AB
Security System Operation: (using the transmitter to arm the security system)
1. Exit the vehicle and close all entrances.
2. Press and release the LOCK button. The security system will respond as follows:
A. The horn/siren will chirp one time.
B. The LED indicator will begin to flash at a steady rate.
C. The parking lights will flash one time.
D. The starter disable device will become armed and the vehicle engine will not crank.
E. All protected entrances are armed.
Note: If the dome light is on or a sensor is active at the time you arm your security system, you will hear
the horn/siren beep one time and then you will hear another beep from the horn/siren about 5 seconds
later. The second beep is the active sensor warning indicator. This second beep tells you that the alarm is
armed but one of the sensors has been temporarily deleted because it was “On” at the time the alarm was
armed.
The security system is now fully armed!
Automatic Arming (without using the transmitter)
Note: The following information is valid only if your security system has been programmed to
automatically arm.
1. Turn off the ignition key and exit the vehicle.
2. Close all protected entrances. After the last protected entrance is closed the horn/siren will chirp one
time and the LED indicator will begin to flash fast. The fast flashing LED indicates that the automatic
arming timer is counting down and the security system will become armed within 30 seconds. After
30 seconds has passed, the security system will respond in the following manner:
2
Automatic Arming (without using the transmitter) (Continued)
A. The horn/siren will chirp one time.
B. The LED indicator will begin to flash slower.
C. The parking lights will flash one time.
D. All protected entrances are armed.
Note 1: Re-opening a protected entrance before the system becomes armed will stop the arming timer.
After closing the entrance the timer will begin counting again from zero.
Note 2: If the vehicle has a delayed interior lighting system, the automatic arming timer will start counting
after the interior lighting has turned itself Off. This could add up to 45 seconds to the total automatic
arming countdown time (up to 75 seconds total arming delay).
The security system is now fully armed!
Disarming the Security System Using the Regular Transmitter (A)
Press and release the UNLOCK button. The security system will respond as follows:
A. The horn/siren will chirp two times.
B1.The LED indicator will be Off (only if Auto Arming is programmed Off).
B2.The LED indicator will be flashing very fast (only if Auto Arming is programmed On).
C. The parking lights will flash two times.
Note: If you are disarming the security system after it has been triggered and the horn/siren is sounding,
the disarm chirps are automatically deleted.
Disarming the Security System Using the Passive Transmitter (B)
Note: When using the passive transmitter the on/off switch must be in the “On” position.
A. Walk toward your vehicle and the security system will respond the same as pushing the UNLOCK
button.
The security system is now disarmed!
Override Switch Operation
Your Carbine security system is supplied with a override switch system. This switch is used to override the
security system in the event that the transmitters are lost or fail to operate, and to put the security system
in non-operational mode.
3
Loading...