MAGNADYNE PL65 Owner's Manual

Model PL65
OWNER'S MANUAL
Remote Control Auto Starter
2
Warnings
Remote Control Transmitters
Remote Auto Starter Operation
On your purchase of our unique remote auto starter system. Please read the enclosed operating instructions to insure you enjoy the numerous benefits available to you.
As with any product that performs automatic functions, there are certain safety precautions that you must practice and be aware of:
1. Keep the transmitter[s] out of children's reach.
2. Do not leave anyone in the vehicle while running on remote control.
3. Alert servicing personnel that the vehicle can be started automatically.
4. Do not start the vehicle by remote while it's in an enclosed area or garage.
5. Always apply the parking brake and lock the vehicle as you exit the vehicle.
6. Should the unit malfunction, disconnect the fuse until the problem is corrected.
7. The use and operations of this system is the sole responsibility of the operator.
8. This system is designed for a fuel-injected vehicle with an automatic transmission.
9. This system must be installed and wired through a safety switch so it will not start in any forward or reverse gear.
10. This system shall never be installed on a vehicle with a manual transmission.
11. Some areas may have local ordinances that prohibit leaving a vehicle running on public streets.
• The remote starter system is interfaced with your factory remote transmitters.
• The range of your factory remotes will determine how far away you can start and turn off your vehicle.
To Remote Start the Vehicle:
• The “LOCK” button on the transmitter starts and turns off the engine.
• Depress the remote transmitter “LOCK” button 3 times within 3 seconds.
• The parking lights will activate to indicate the remote start received the signal.
• The ignition circuits will activate and the engine will start approximately [5] seconds later.
• Once the engine is running on remote control, the climate controls will activate and adjust the vehicles interior temperature to your preset settings.
• The vehicle will run for the 14 or 21 minute cycle and automatically turn “off”.
To Turn Off the Remote Starter:
• Once you have activated the remote starter, depressing the “LOCK” button again 3 times within 3 seconds will turn it “off”.
To Operate The Vehicle While Running on the Remote Starter:
• Depress the remote transmitter “UNLOCK” button to unlock the doors.
• Insert and turn “on” the ignition key [two positions] and drive off.
• When you depress the brake pedal, the remote starter will turn “off”. Therefore, if you accidentally depress the brake pedal before you turn “on” the ignition key, the remote starter will turn “off” and the engine will die. If this happens, simply restart the engine with the ignition key and drive off.
Temporary Stop Feature:
This feature allows you to exit and leave the vehicle running on remote control. Note: This feature may not be operable on your vehicle due to limitations and operation of the factory
remote transmitter.
Loading...
+ 2 hidden pages