Magnadyne PL30 User Manual

OWNER’S

MANUAL

Model: PL30

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference; and (2)

This device must accept any interference received, including interference that may cause undesired operation.

Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment. © Copyright 1998 Magnadyne Corp.

Remote Mobile Security System

The information enclosed will provide a ready reference of the operation and maintenance of your new remote mobile security system.

1. Exit the vehicle and close all entrances.

2. Press and release the ARM/DIS or LOCK button on the transmitter. The security system will respond as follows:

A. The horn/siren will chirp one time. B. The LED indicator will begin to flash at a steady rate. C. The parking lights will flash one time. D. All protected entrances are armed.

Note: If the dome light is on or a sensor is active at the time you arm your security system, You will hear the horn/siren beep one time and then you will hear another beep from the horn/siren about 5 seconds later. This second beep is the active sensor warning indicator. This second beep tells you that the alarm is armed but one of the sensors has been temporarily deleted because it was on at the time the alarm was armed.

The security system is now fully armed!

Your security system can operate from any one of the four transmitters shown here. Locate the transmitter that was supplied with your system and use the drawing as a ready reference while reading through the operating procedures.

Silent Arming

ARM/DIS

Button

AUX CH#2

Button

Silent Arming

ARM/DIS

Button

AUX CH#2

Button

Silent Arming

AUX CH#2

Button

ARM/DIS

Button

PANIC AUX

LOCK

UNLOCK

Silent Arming

LOCK/ ARM

Button

AUX CH#2

Button

UNLOCK/

DISARM

Button

PANIC Button

Security System Operation: (Using the transmitter to arm the security system)

Remote Control Transmitters

Note: The following information is valid only if your security system has been programmed to automatically

arm.

1. Turn off the ignition key and exit the vehicle.

2. Close all protected entrances. After the last protected entrance is closed the horn/siren will chirp one time and the LED indicator will begin to flash fast. The fast flashing LED indicates that the automatic arming timer is counting down and the security system will become armed within 30 seconds. After 30 seconds has passed, the security system will respond in the following manner:

A. The horn/siren will chirp one time. B. The LED indicator will begin to flash slower. C. The parking lights will flash one time. D. All protected entrances are armed.

Note 1: Re-opening a protected entrance before the system becomes armed will stop the arming timer . After closing the entrance the timer will begin counting again from zero.

Note 2: If the vehicle has a delayed interior lighting system, the automatic arming timer will start counting after the interior lighting has turned itself off. This could add up to 45 seconds to the total automatic arming countdown time. (Up to 75 seconds total arming delay)

The security system is now fully armed!

Press and release the ARM/DIS or UNLOCK button on the transmitter. The security system will respond as follows:

A. The horn/siren will chirp two times. B1.The LED indicator will be off. (Only if Auto Arming is programmed off) B2.The LED indicator will be flashing very fast. (Only if Auto Arming is programmed on) C. The parking lights will flash two times.

Note: If you are disarming the security system after it has been triggered and the horn/siren is sounding, the disarm chirps are automatically deleted.

The security system is now disarmed!

Automatic Arming: (Without using the transmitter)

Disarming the Security System Using the Transmitter

+ 5 hidden pages