MAGNADYNE LS6100W Owner's Manual

OWNER'S MANUAL

LS6100

AM/FM Stereo Receiver and Auto Stop Cassette Player

Designed for In-Wall Installation of All Recreational Vehicles, Motor Homes and Mobile Housings
12 Volts DC

A Registered Trademark of Magnadyne Corporation

© Copyright 1998 Magnadyne Corp.

®

INTRODUCTION

Please read all of the information in this booklet before using
this unit to insure that you fully understand the capabilities of
this unit.

WARNING! To prevent fire or electrical shock hazard, do not
expose this product to rain or moisture, or remove cover or
bottom screws. No user serviceable parts inside. Refer
servicing to qualified service personnel.

2

CONTROLS AND FUNCTIONS

1

2

12

13

14

6 7 8 9 10

5

11

4

315

16

17

AM

LS6100

ON/ OFF

PLAY

PHONES

540 600 700 800 1000 1200 1400 1600

FM 88 92 96 100 104 108

SPEAKER A SPEAKER B

REW F.F.

TUNING

KH

STEREO

Z

MH

Z

CD IN

VOLUME

STOP/
EJECT

PAUSE

LOW

GRAPHIC EQUALIZER

+12

+6

0

-

6

-

12

HIGH

+12

+6

0

-

6

-

12

10kHz1kHz100Hz

AM AUX

FM

BALANCE

LR

CONTROLS AND FUNCTIONS

1. On/Off Button

Press this button in to turn the unit on. Press again to turn the
unit off.

2. AM/FM/ AUX Function Selector

After turning the unit on, select the desired playing mode with
this selector.

3. FM Stereo Indicator Light

When the tuner is receiving a strong stereo FM signal, the
stereo light will be lit.

4. Radio Station Tuning Knob

Rotate this knob to locate the radio station that you desire.
Rotating it clockwise will take you up the frequency band and
rotating it counter-clockwise will take you down the frequency
band.

5. Cassette Carriage Door

By pressing the cassette stop / eject button (9) the door will
open to allow you to insert a tape.

6. Play Button

After inserting a cassette tape press this button to begin tape
play.

7. Fast Rewind Button

To fast rewind the tape, press this button until it locks. To
release the button press the stop/eject button.

8. Fast Forward Button

To fast forward the tape, press this button until it locks. To
release the button press the stop/eject button.

3

9. Stop/Eject Button

When this button is pressed, tape play will stop and the
cassette carriage door will open to allow you to remove the
tape.

10. Pause Button

Pressing this button will stop the tape until the button is
released.

11. Dial Indicator

The dial indicator will move up and down the scale as you
rotate the tuning knob (4) indicating the station you are
listening to.

12. 3-Band Graphic Equalizer

These controls will tailor the overall tone of the unit. Slide
these controls up and down to achieve a tone that will suit
your taste.

13. Balance Control

Sliding this knob from left to right will allow you to balance
the sound to suit your taste.

14. Volume Control Knob

Rotate this knob to increase the volume of the unit.

15. Speaker A/B Selector Buttons

To play the "A" set of speakers, press the "Speaker A"
button. To play the "B" set of speakers, press the "Speaker
B" button. To play the "A" and "B" speakers at the same
time, press both buttons in.

4

FM Stereo Operation

The unit will automatically switch from FM mono to FM stereo
when the signal strength increases to a stereo level. If the signal
should become weak on stereo reception, the unit will switch
back to the mono mode.

Note: Stereo operation is indicated by the stereo light (3) on the
front of the unit.

Tape Operation

1. Press the on/off button (1) to turn the unit on.

2. Press the stop/eject button (9) to open the cassette door.

3. Insert a cassette tape in the cassette carriage with the tape
opening down and the programs you want to listen to facing
you. Close the tape carriage door.

4. Press the play button (6).

5. To stop the tape play, press the stop/eject button (9) once.

6. To release the tape carriage door and eject the tape, press
the stop/eject button (9) again and the door will open.

Fast Forward and Fast Rewind

To fast forward or rewind a tape, press the fast forward button
(



) or the rewind button () until it locks. To release the

button, press the stop / eject button (



) once. To resume normal

play, press the play button (



).

AUX Operation

1. Set function knob (2) to the AUX position.

2. Turn on the item connected to the AUX inputs.

3. The volume, tone and balance controls will operate normally.

CONTROLS AND FUNCTIONS

16. CD Input

Plug one end of a CD jumper cable into this receptacle and
plug the other end into the "line out" receptacle or
"headphone" receptacle of your portable CD player

It is strongly recommended to use the "line out" receptacle of
the portable CD player. The LS6100's volume, balance and
equalizer controls will operate normally when the CD input is
used

17. Headphone Output

The headphone jack accepts a standard walkman type
headphone plug (3.5mm). When the headphones are
plugged into the headphone jack, all external speakers are
turned off.

Radio Operation

1. Press the on/off button (1) in to turn the unit on.

2. Use the function selector (2) to select the AM or FM radio
band.

3. Tune in the desired radio station by rotating the tuning knob
(4).

4. Adjust the volume, balance and 3-band equalizer controls as
desired.