Magnadyne DVU-2 User Manual

The DVU-2 is a Dual VPA Socket and USB Port Adapter. This unit can be mounted in two ways:

Attach the Mounting
Tab s to the Unit

Mount the
Unit in an
Accessible Area

Apply the Velcro Pad to the Unit

Connect the Red Stripped Wire
to a Fused 20A Power Source

Connect the Black Wire
to Chassis Ground

Screw Mount and Velcro®Mount. Choose a mounting location that provides easy access and LED
is clearly visible. Follow the diagrams below for proper installation.

Mounting the Unit

Dual VPA Socket and USB Port Adapter

Model: DVU-2

Installation Sheet

Screw Mount:

The DVU-2 comes with flat head screws to facilitate mounting
the unit to the dashboard or some other accessible area in the
vehicle.

1. Attached the mounting tabs to the unit with the screws
provided.

2. Once tabs are attached use remaining screws to mount
unit in an accessible area.

Velcro Mount:

The DVU-2 comes with a Velcro pad for mounting the unit to the
dashboard or some other accessible area in the vehicle.

1. Make sure the surface area on the unit where the Velcro will
adhere to, and the surface you are adhering it to are clean.

2. Remove the backing on one side of the Velcro pad.

3. Apply the Velcro pad to specified area on the unit.

4. Remove the backing on the other side of the Velcro pad and
then press the unit firmly into the designated mounting
location.

Optional Hard Wiring

© 2007 Copyright Magnadyne Corporation

Hard Wiring:

The DVU-2 VPA plug can be removed to allow for hard wiring of
the unit when permanently installing it in a vehicle

1. Cut off the VPA connector making sure to leave the appro­priate length of cable to reach your connection point.

2. Connect the red stripped wire to a fused 20A power source.

3. Connect the black wire to chassis ground.

.

DVU-2-INS Rev. A 12-27-06