Owner’s/ Installation Manual
Color Side View
Security Camera
Models: C-SDL Left
C-SDR Right
For Technical Assistance, please call (800) 638-3600,
or visit www.magnadyne.com
Introduction
1
2
3
1. +12 Volts
4. Video 2. N/A
5. Ground
3. N/A
Housing Screw
Housing Screw
Gasket
Mounting Screw,
Lock Washer and
Washer
(Supplied)
Congratulations on your purchase of a quality MobileVision Side View Security Camera. This camera
has been designed to provide you with a product that is technologically superior and provide years of
trouble free operation.
The information enclosed provides a quick reference of the operations and maintenance of your new
Side View Security Camera.
This product must be installed and used in accordance with this manual. Any alterations to this product that enables it to be used in any way other than intended or designed could distract the driver and
result in an accident causing injury or death. Magnadyne Corporation disclaims any and all liability
that may result from failure to install and operate in any other manner in which this was intended.
Camera Features
1. Adjustable Viewing Angle
2. 1/3" Color CCD Camera Lens
3. Waterproof Housing
Mounting the Camera
1. Select a position to mount the camera that is
2. Remove the housing from the camera by
3. Use the camera’s mounting base as a tem-
2
free of obstructions and moving parts and has
a proper viewing angle of the side the vehicle.
loosening the housing screw in the back of
unit using the supplied allen wrench.
plate to drill mounting holes and a 5/8"
cable pass-through hole.
4. Attach the gasket to the bottom of the
mounting bracket.
5. Align the mounting bracket with pre-drilled
holes then secure bracket with screws.
6. Insert the camera cable into the passthrough hole. Use silicone to seal the
pass-through hole.
7. Reinstall the housing and tighten the
housing screw.
Adjusting the Camera
Adjustment Screws
Do Not Adjust
Do Not Adjust
Marking on Camera
Housing Indicates
Up Position
1. With the housing removed, loosen the
adjustment screws located near the base of
the camera.
2. Adjust the camera to the desired viewing
angle.
3. Tighten the adjustment screws to lock
camera into place.
Note: Do not over tighten the screws.
4. Reinstall the housing.
Warning
Backing Up Your Vehicle
The product is intended to assist in safe driving and allows the driver to have a broader field of
vision during backup. You, as the driver, are solely responsible for the safe operation of your vehicle and the safety of your passengers and pedestrians, and abiding all state and local traffic regulations. Do not use any features of this system to the extent it distracts you from safe driving. Your
first priority while driving should always be the safe operation of your vehicle. Magnadyne will not
accept any responsibility whatsoever for accidents and/or injuries resulting from failure to observe
these precautions or safety instructions.
Maintenance
Although this Side View Security Camera requires little care, you can still maintain its condition and
performance by following these steps:
• Occasionally clean the camera lens with damp soft cloth.
Should you experience any problem with the camera please refer to the troubleshooting guide
below prior to returning your camera for repair.
Note: The user should not attempt to service the unit beyond that described in the operating
instructions. All other servicing should be referred to qualified personnel.
Troubleshooting
Symptoms
Cloudy Image
No Power / Image
Upside Down Image
Unstable Image
Solutions
• Clean Dirty Camera Lens
• Check Power Connections
• Check Camera Mounting
• Check Mounting Hardware
• Check Power Connections
3
Specifications
Image Sensor: 1/3" Sharp Color CCD with Low Illumination
Board Lens: 2.8 mm
Resolution: 420 TV Lines
Diagonal Lens Angle: 120°
Minimum Illumination: 1 Lux
Power Consumption: 120 mA
Camera & Bracket Weight: 350g
Operating Temperature: -20°C ~ -70°C
S/N Ratio: 48dB (AGC On)
Sync System: Internal Synchronization
Video Output: 1.0Vp-p 75 ohm
Water Resistance: Ip66
Warranty
ONE (1) YEAR LIMITED WARRANTY
Magnadyne Corporation or its authorized agents will within one year from the date of sale
to you, repair, replace or refund the retail sales price of said product or any part thereof, at
the option of the Magnadyne Corporation or its authorized agents, if said product or part
is found defective in materials or workmanship, when properly connected and operating on
the correct power requirements designated for the specific product. This warranty and
Magnadyne Corporation or its authorized agent’s obligations hereunder do not apply where
the product was; damaged while in the possession of the consumer, subjected to unreasonable or unintended use, not reasonably maintained, utilized in commercial or industrial
operations, or serviced by anyone other than Magnadyne Corporation or its authorized
agents, or where the warning seal on the product is broken or the power and/or plugs are
detached from the unit. Magnadyne Corporation or any of its authorized agents will not
assume any labor costs for the removal and reinstallation of any product found to be defective, or the cost of transportation to Magnadyne Corporation or its authorized agents. Such
cost are the sole responsibility of the purchaser.
This warranty does not cover the cabinet appearance items or accessories used in connection with this product, or any damage to recording or recording tape, or any damage to
the products resulting from improper installation, alteration, accident, misuse, abuse or
acts of nature.
MAGNADYNE CORPORATION OR ITS AUTHORIZED AGENTS SHALL NOT BE LIABLE TO
ANYONE FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES OR CLAIMS EXCEPT THOSE
ACCORDED BY LAW. NO EXPRESSED WARRANTY OR IMPLIED WARRANTY IS GIVEN
EXCEPT THOSE SET FORTH HEREIN. NO IMPLIED WARRANTY SHALL EXTEND BEYOND
ONE YEAR FROM THE DATE OF SALE.
This warranty extends only to the original purchaser of the product and is not
transferable. Some states do not allow limitations on how long an implied warranty lasts,
and some states do not allow the exclusion or limitation of incidental or consequential
damages, so the above limitations or exclusion may not apply to you. This warranty gives
you specific legal rights, and you may have other rights that vary from state to state.
“NOTE: The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the User’s
authority to operate the equipment.”
Defective merchandise should be returned to the original point of purchase or
secondly, to Magnadyne Corporation, 1111 W. Victoria Street, Compton CA 90220.
Return Authorization must be obtained before sending, or merchandise may be refused.
Copyright © 2008 Magnadyne Corp.
C-SDL/R-UMIM Rev. A 3-20-08
Loading...