Magikitchn 600 Series Operation Manual

Orifice Tip Replacement Procedure

Series 600 Quick Reference Card

The following procedure describes the steps to change or replace the
main burner gas orifice(s) on Series 600 appliances, All Options.

Note: This procedure should be performed with the main gas supply
shut off and disconnected.

1

Standard Input Models

1/2" Deep Socket

w/ Extension

Hi Input Models

1/2" & 7/16" Deep Socket

w/ Extension

7/16" Open End Wrench

Recommended Tools Turn off the main gas supply.

2

3

Remove Top Grids, Radiants or

Coal Screens.

5

4

For Hi Input Models, use the

7/16" deep socket, and 7/16"

wrench to remove mounting bolt

and nut from the burner.

6

For Standard Input Models, pull

the hitchpin from the burner

mounting flange.

L80-054 1 Rev 0 (7/08)

Lift the burner up, and pull it out

from the burner orifice. It is the

same motion for all Models.

Orifice Tip Replacement Procedure

Tighten orifice onto the valve until

connections, and rated for use in elevated temperature zones.

Series 600 Quick Reference Card

Note: Brass to brass piping connections should not require any
thread tape or sealer compounds. If gas leaks are detected and
thread sealants are used, the sealant should be suitable for gas

7

Locate exposed main burner

orifice, check thread depth.

9

8

Remove the existing burner

orifice with the 1/2" deep socket.

10

Thread new orifice onto the

burner valve finger tight.

11

Replace burner, securing burner

in place with nut and bolt, or the

hitchpin, depending on Model.

L80-054 2 Rev 0 (7/08)

the thread depth from the

previous orifice is matched.

12

Repeat procedure for all burner

orifices to be replaced.

Orifice Tip Replacement Procedure

Series 600 Quick Reference Card

Note: The manifold gas pressures may change due to an orifice

replacement, make sure the appliance is operating in accordance

with the manufacturers operators manual.

1413

Check for gas leaks, and set

gas pressures in accordance

with the Pitco P&I checklist,

Part No. L14018, at the

conclusion of this procedure.

The use of Personal Protective

Equipment is recommended.

Replace Radiants or Coal

Screens, and Top Grids to their

original positions.

In the event of problems with or questions about your
equipment, please contact the MagiKitch’n Authorized Service
and Parts representative (ASAP) covering your area, or contact

MagiKitch’n at the numbers listed below.

[phone] US and Canada only

or [phone] World Wide

Website Address: www.magikitchn.com

L80-054 3 Rev 0 (7/08)