Application Note
Interface Cable/Software Compatibility Information
Certain interface cables will only operate with specific loggers. They are as
follows:
IFC200 (USB interface cable w/ 3.5mm headphone plug)
Will work with all MadgeTech loggers EXCEPT
:
• Transi-Temp-EC (Single and Multi-Use versions) Yellow case loggers
• MicroTemp and MicroRHTemp data loggers
IFC110 (9-pin serial interface cable w/ 3.5mm headphone plug)
Will work with all MadgeTech loggers EXCEPT
:
• Transi-Temp-EC (Single and Multi-Use versions) Yellow case loggers
• MicroTemp and MicroRHTemp data loggers
IFC102 (9-pin serial interface cable w/ 3.5mm headphone plug and 3.5 to 2.5mm adapter)
Necessary for the following loggers, ONLY
:
• MicroTemp and MicroRHTemp loggers require this cable and adapter plug
IFC103 (9-pin serial interface cable with special interface, base station)
Works with these loggers, ONLY
:
• Transi-Temp-EC (Single and Multi-Use versions) Yellow case loggers
(The interface on this interface/base station is a hard-wired, 9-pin serial plug. This part number requires the
use of a USB to Serial adapter to become USB capable. We offer the USB-1, USB to Serial Adapter that will
work with this cable to convert it to USB)
RFC101A - (RF, wireless receiver for use with RF loggers.)
pin serial plug. This part number requires the use of a USB to Serial adapter to become USB capable. We
offer the USB-1, USB to Serial Adapter that will work with this device to convert it to USB. Necessary for
the following loggers, ONLY
:
• RF Logger Series
IFC202 (USB interface cable w/ 3.5mm headphone plug and 3.5mm to 2.5mm adapter)
Necessary for the following loggers, ONLY
:
• MicroTemp and MicroRHTemp loggers require this cable and adapter plug
The interface on this receiver is a hard-wired, 9-
MadgeTech, Inc.
(603) 456-2011 Phone
(603) 456-2012 Fax
www.madgetech.com
support@madgetech.com
201 Route 103 West
PO Box 50
Warner NH 03278
Pasteurization & Sterilization Application Note DOC-00970000-00 Revised: April 11, 2006