GaAs SP4T Absorptive Switch with
V 6.00
ASIC Driver, DC - 3.0 GHz
SW65-0314
Features
n Typical Isolation: 33 dB (2,000 MHz)
n Typical Insertion Loss: 1.6 dB (2,000 MHz)
n Integral ASIC TTL/CMOS Driver
n Plastic, 50 mil Pitch, SOW-24 Lead, Wide Body
n Low DC Power Consumption
n 50 Ohm Nominal Impedance
n Tape and Reel Packaging Available
n Test Boards Available
Description
M/A-COM's SW65-0314 is a GaAs MMIC absorptive
SP4T switch with an integral silicon ASIC driver. This
device is in a 24-lead plastic package. This switch offers
excellent broadband performance and repeatability from DC
to 3 GHz, while maintaining low DC power dissipation.
The SW65-0314 is ideally suited for wireless infrastructure
applications. Also available in a ceramic package with
improved performance.
SOW-24
Package outline conforms to JEDEC standard MS-013AD.
Electrical Specifications: TA = 25°C
Parameter Test Conditions Units Min Typical Max
Insertion Loss DC - 1.0 GHz
Isolation
(All arms off)
VSWR
T
T
rise
Ton T
Transients
1 dB Compression .05 GHz
Input IP3 Two tone inputs 0.05 GHz
Logic “0” Iin = 20 µA max V 0.0 — 0.8
Logic “1” Iin = 20 µA max V 2.0 — 5.0
fall
off
VCC — V +4.5 +5.0 +5.5
VEE — V -8.0 -5.0 -4.75
ICC VCC = +5.0V mA — 0.2 6
IEE VEE = -5.0V mA — -0.2 -1
DC - 2.0 GHz
DC - 3.0 GHz
DC - 1.0 GHz
DC - 2.0 GHz
DC - 3.0 GHz
DC - 1.0 GHz
DC - 2.0 GHz
DC - 3.0 GHz
10%/90%, 90%/10%
50% TTL to 90%/10% RF
In-band (peak to peak)
.5 - 3.0 GHz
Up to +5 dBm 0.5 - 3.0 GHz
1
dB
dB
dB
dB
dB
dB
—
—
—
nS
nS
mV
dBm
dBm
dBm
dBm
—
—
—
35
30
25
—
—
—
—
—
—
—
—
—
—
1.5
1.6
2.0
38
33
27
On Off
1.3:1 1.3:1
1.5:1 1.7:1
1.7:1 2.2:1
15
50
50
+20
+27
+35
+46
1.7
1.8
2.3
—
—
—
1.5:1
2.0:1
2.4:1
50
150
150
—
—
—
—
1. Decoupling capacitors (.01 µF) are required on the power supply lines.
GaAs SP4T Absorptive Switch with ASIC Driver, DC - 3.0 GHz
SW65-0314
V 6.00
Absolute Maximum Ratings
Parameter Absolute Maximum
Max. Input Power
0.05 GHz
0.5 - 3.0 GHz
Bias Voltages
VEE
VCC
Control Voltage 4
Operating Temperature -40°C to +85°C
Storage Temperature -65°C to +125°C
2. Operation of this device above any one of these parameters
may cause permanent damage.
3. When the RF input is applied to the terminated port, the
absolute maximum power is +30 dBm.
4. Standard CMOS TTL interface, latch-up will occur if logic
signal is applied prior to power supply.
-0.5V to VCC +0.5V
2,3
+27 dBm
+34 dBm
-8.5V
+5.5V
Truth Table
TTL Control Input
C1 C2 C3 C4 RF1 RF2 RF3 RF4
1 0 0 0 On Off Off Off
0 1 0 0 Off On Off Off
0 0 1 0 Off Off On Off
0 0 0 1 Off Off Off On
RF Common To:
Pin Configuration
Pin # Function Pin # Function
1 RFc 13 C1
2 GND 14 C3
3 RF4 15 GND
4 GND 16 GND
5 GND 17 GND
6 RF2 18 GND
7 GND 19 RF1
8 V
9 GND 21 GND
10 V
11 C4 23 GND
12 C2 24 GND
EE
CC
20 GND
22 RF3
Ordering Information
Part Number Package
SW65-0314 Bulk Packaging
SW65-0314TR Tape and Reel (1K Reel)
SW65-0314-TB Units Mounted on Test Board
Typical Performance Curves
Typical Insertion Loss Variation at
Temperature - Jx-J0
-40°C
2.5
2.0
1.5
1.0
Loss (dB)
0.5
0.0
0 500 1000 1500 2000 2500 3000
Specifications subject to change without notice.
n North America: Tel. (800) 366-2266
n Asia/Pacific: Tel.+81-44-844-8296, Fax +81-44-844-8298
n Europe: Tel. +44 (1344) 869 595, Fax+44 (1344) 300 020
Visit www.macom.com for additional data sheets and product information.
+25°C
Frequency (MHz)
+85°C
2