M A COM SW10-0313 Datasheet
Matched GaAs SPDT Switch, DC - 3
SW10-0313
GHz with TTL/CMOS Control Input
Features
n Integral TTL Driver
n Low DC Power Consumption
n Surface Mount Package
n Low Cost/High Performance
n 50 Ohm Nominal Impedance
Description
M/A-COM’s SW10-0313 is a GaAs FET SPDT absorptive
switch with integral silicon ASIC driver. Packaged in a
16-lead ceramic surface mount package, this device offers
excellent performance and repeatability from DC to 3 GHz
while maintaining low power consumption. The
SW10-0313 is ideally suited for use where fast speed, low
power consumption and broadband applications are
required.
CR-9
V 4.00
Electrical Specifications
Parameter Test Conditions Frequency Units Min Typ Max
Insertion Loss — DC - 3000 MHz
VSWR — DC - 3000 MHz
Isolation — DC - 3000 MHz
Trise, Tfall 10% to 90% — ns — 50 —
Ton, Toff 1.3V CTL to 90% / 10% — ns — 150 —
Transients In-Band — mV — 50 —
1 dB Compression Input Power 0.05 GHz
IP2 Two-Tone Input Power up to +5 dBm 0.05 GHz
IP3 Two-Tone Input Power up to +5 dBm 0.05 GHz
Vin Low 0V to 0.8V — µA — — 1
Vin High 2.0V to 5.0V — µA — — 1
1,2
TA = +25°C
DC - 2000 MHz
DC - 1000 MHz
DC - 500 MHz
DC - 2000 MHz
DC - 1000 MHz
DC - 500 MHz
DC - 2000 MHz
DC - 1000 MHz
DC - 500 MHz
0.5 GHz to 3 GHz
0.5 GHz to 3 GHz
0.5 GHz to 3 GHz
dB
dB
dB
dB
Ratio
Ratio
Ratio
Ratio
dB
dB
dB
dB
dBm
dBm
dBm
dBm
dBm
dBm
—
—
—
—
—
—
—
—
35
45
45
50
—
—
—
—
—
—
0.8
0.7
0.7
0.6
1.2:1
1.2:1
1.2:1
1.1:1
40
50
50
55
+25
+30
+60
+65
+40
+46
1.2
1.1
0.9
0.8
1.4:1
1.35:1
1.35:1
1.3:1
—
—
—
—
—
—
—
—
—
—
1. All specifications apply when operated with bias voltages of +5V for Vcc and –5V for Vee.
2. When DC blocks are used, a 10K ohm return to GND is required on the RFC port.
Matched GaAs SPDT Switch, DC - 3 GHz with TTL/CMOS Control Input
Electrical Specifications: TA = +25°C
Parameter Test Conditions Frequency Units Min Typ Max
Vcc +5.0V ± 10% — mA — — 1
Vee -5.0V to -8.0V — mA — — 1
SW10-0313
V 4.00
Pin Configuration
Pin No. Function Pin No. Function
1 Vee 9 RFC
2 GND 10 GND
3 GND 11 GND
4 GND 12 RF1
5 RF2 13 GND
6 GND 14 GND
7 GND 15 Vcc
8 GND 16 C1
Absolute Maximum Ratings 3
Parameter
Max Input Power
50 MHz
500 - 2000 MHz
Supply Voltages
Vcc
Vee
Control Voltage 4 -0.5V, to Vcc +0.5V
Operating Temperature -40°C to +125°C
Storage Temperature -65°C to +150°C
Absolute Maximum
+27 dBm
+34 dBm
+5.5V
-8.5V
Pin Configuration (Top View)
RFC
GND
GND
RF1
GND
GND
Vcc
C1
GND
GND
GND
RF2
GND
GND
GND Orientation Mark
Vee
Truth Table
C1
LO On Off
HIGH Off On
Condition of Switch
RF Common to Each RF Port
RF1 RF2
3. Operation of this device above any one of these parameters
may cause permanent damage.
4. Standard CMOS TTL interface, latch-up will occur if logic
signal is applied prior to power supply.
Specifications subject to change without notice.
n North America: Tel. (800) 366-2266
n Asia/Pacific: Tel.+81-44-844-8296, Fax +81-44-844-8298
n Europe: Tel. +44 (1344) 869 595, Fax+44 (1344) 300 020
Visit www.macom.com for additional data sheets and product information.
2
Loading...